Advertisement
8-pin mini-DIN PGM-SW
1. Turn the main REAR power switch OFF.
2. Connect a RS-232C straight cable to the CAT connector.
3. Open the file FSW003.
4. Insert the 8-pin mini-DIN PMG-SW connector to FT-2000/D (PMG) jack.
5. Turn on the REAR Main power switch.
6. I choose the .sfl file of the version 0151 to write in and push WRITE of the screen.
7. When complete appears, click OK. Turn the REAR power switch OFF.
8. Remove the 8-pin mini-DIN PMG-SW and the RS-232C cable.
9. Turn on REAR power switch.
10. Reset the radio to default.
NOTE:
for a more detailed description see the Main CPU programming.
This procedure is used for uploading new EDSP Software into the FT-2000/D Amateur Transceivers,
from your personal computer, using the RS-232C, DB9F to DB9F straight cable.
1. Turn off the main power switch located on the back of the FT-2000 (or turn off the power supply
for FT-2000D and wait a minute, until the capacitors discharge) and remove the AC power cord.
2. Connect a serial RS-232C, DB9F to DB9F straight cable to the COM1 connector of your
computer and the 9-pin CAT connector on the rear of the transceiver. If you use a USB to serial
adapter, you might need to change the COM Port number.
3. Reconnect the power cord and turn ON the main power switch located on the back of the FT-2000
(or turn ON the power supply for FT-2000D).
4. While holding the [DNR]＋[CONT]＋[DNF] buttons, press the front power switch to turn the
radio on. You will see
5. On your computer desk top open PEP2000_EDSP folder and find the EDSP V302 icon as shown
below. Double-click the EDSP V302 icon, displayed on the Program Screen.
EDSP
EDSP Software Update
[dSP Prg NO
1] on the radio display.
Main Power SW
CAT
Advertisement
