Electrolux EWF 1029 Instruction Booklet page 9

5 "START/PAUSE" button
After having selected the required programme,
press this button to start the machine; the
corresponding pilot light stops flashing and
remains lit.
To interrupt a programme which is running,
depress the Start/Pause button: the
corresponding pilot light starts to flash.
To restart the programme from the point at
which it was interrupted, press the
START/PAUSE button again.
6 Programme progress display
When you select the programme, the lights relevant
to the phases that form the programme light up.
After the machine has started, only the running
phase pilot light stays on.
: when this light comes on this means that
/
the machine is performing the washing phase. If
you have selected the "Prewash"
light will be on during the prewash phase too.
= rinses
= spin
= drain
= end of programme
At the end of the programme the
illuminates.
The pilot light also flashes in the event of
operating problems:
- 4 flashes = the door has not been closed
- 2 flashes = the machine does not empty
- 1 flash = the machine does not fill
To eliminate the problem, see paragraph "Something
not working".
7 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetics
• Delicates
• Wool
• Special programmes
The selector dial can be turned either clockwise
or anticlockwise.
Position
Position O corresponds to Reset
function, this
programme/Switching OFF of the machine.
At the end of the programme the selector dial
must be turned to position O, to switch the
machine off.
ATTENTION!
If you turn the programme selector dial to another
programme when the machine is working, the lights
pilot light
of the programme progress display start to flash.
The machine will not perform the new selected
programme.
9
corresponds to "cold wash".