Electrolux EWF 1029 Instruction Booklet page 13

7. How to change a programme during
its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme. The
washing water remains in the tub. Start the new
programme by depressing the START/PAUSE
button.
Note: To drain the water before starting the new
cycle, you have to cancel the programme and select
the DRAIN cycle.
8. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
9. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
selector dial to "O". After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!).
.
10. At the end of the programme
The machine stops automatically.
The START-PAUSE
END pilot light comes on. The door can be
opened.
If the Rinse Hold
END pilot light remains lit and the door is locked
to indicate that the water must be emptied out
before opening the door.
To do this turn the programme selector dial to "O"
and then to programme
The spin programme is performed at the maximum
speed.
Switch the machine off by turning the programme
selector dial to "O".
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
13
pilot light goes out and the
option has been selected, the
(drain) or (short spin).