Table of Contents
Advertisement
Quick Links
Thank you for buying a Turf Cruiser™/Trail Cruiser™ Utility Vehicle! Before operating your machine, read this
manual carefully and pay particular attention to the "IMPORTANT SAFETY INSTRUCTIONS" on Pages 2 thru 6.
Remember that all power equipment can be dangerous if used improperly. Also keep in mind that SAFETY
requires careful use in accordance with the operating instructions and common sense!
NOTE: Specifications are correct at time of printing and are subject to change without notice.
* Actual sustained equipment horsepower will likely be lower due to operating limitations and environmental factors.
† Turf Cruiser™ & Trail Cruiser™ utility vehicles are manufactured by Snapper Products Inc., McDonough, GA 30253.
MANUAL CONTENT COPYRIGHT © 2004
SNAPPER – A DIVISION OF SIMPLICITY MFG. INC.
ALL RIGHTS RESERVED
Safety Instructions & Operator's Manual For
TURF CRUISER
TRAIL CRUISER
UTILITY VEHICLES
SERIES 1
UV1621BV
UVG1621BV
UVGT1621BV
UVGT1621BV shown
NOTE: Not all utility vehicle models
come with accessories shown above.
MANUAL No. 7026153 (Rev. 2, 11/11/04)
TP 100-5107-2-GC-N
™
™
†
(7085668)
(7085632)
(7085903)
Advertisement
Table of Contents
Related Manuals for Snapper 1 Series
Summarization of Contents
IMPORTANT SAFETY INSTRUCTIONS
Protection for Children
Guidance on preventing accidents involving children and the machine.
Protection Against Tip-overs
Measures to prevent tip-over accidents and ensure operator safety.
Carrying Loads
Instructions and precautions for safely carrying loads in the cargo bed.
Safe Handling of Gasoline
Precautions for safe refueling and storage of gasoline.
Operation
General guidelines and warnings for operating the utility vehicle.
Maintenance
General overview of maintenance procedures and intervals.
SECTION 1 – FAMILIARIZATION
1.1 Introduction
Overview of the manual's purpose and scope for utility vehicles.
1.2 Nomenclature
Identification of essential vehicle parts and components.
CONTROL IDENTIFICATION & SAFETY SIGNS
DANGER - Operator Protective Structure
Critical safety warning regarding the Operator Protective Structure.
SECTION 2 – OPERATING INSTRUCTIONS
2.1 Pre-Start Check List
Essential checks to perform before starting the machine.
2.2 Controls – Function and Operation
Detailed explanation of vehicle controls and their functions.
2.3 Starting and Stopping Engine
Step-by-step guide for starting and stopping the engine.
2.4 Starting and Stopping Machine Motion
Procedures for moving the machine forward and in reverse.
2.7 Driving the Machine
General guidelines for driving the utility vehicle.
2.8 Carrying Loads
Safe practices for carrying loads, including capacity limits.
2.9 Towing
Guidelines and safety measures for towing with the vehicle.
2.12 Powerlink™ On-Board Generator System
Information and warnings for the optional Powerlink generator system.
SECTION 3 – MAINTENANCE
3.2 Service - After First 5 Hours
First service interval procedures for the vehicle.
3.3 Service – Every 25 Operating Hours
Maintenance tasks required every 25 operating hours.
3.4 Service – Every 50 Operating Hours
Maintenance tasks required every 50 operating hours.
3.6 Service – Every 200 Operating Hours (or Yearly)
Maintenance tasks required every 200 hours or annually.
3.7 Storage (Out of Season)
Procedures for storing the machine during off-season.
SECTION 4 – ADJUSTMENTS & REPAIRS
4.1 Drive Belt Replacement
Step-by-step guide for replacing the drive belt.
4.2 Service Brake & Park Brake Adjustment
How to adjust the service and park brakes for proper function.
4.3 Battery
Information and procedures related to the vehicle's battery.
4.5 Transmission Shift Rod Adjustment
Procedure for adjusting the transmission shift rod if needed.
SECTION 5 – ELECTRICAL
Wiring Schematic
Diagram illustrating the vehicle's electrical wiring system.
TROUBLESHOOTING
Engine Will Not Start Using Electric Starter
Troubleshooting steps for engine starting issues.
Engine Stalls After Running
Diagnosing and resolving engine stalling problems.
Engine Loses Power
Causes and solutions for engine power loss.
Machine Will Not Move. Loss Of Traction.
Troubleshooting steps when the machine won't move or has loss of traction.
1 YEAR LIMITED WARRANTY
Disclaimer of Warranty
Legal limitations and exclusions of implied warranties.
PRODUCT REGISTRATION FORM
Warranty Registration
Instructions for registering the product to ensure warranty coverage.
Need help?
Do you have a question about the 1 Series and is the answer not in the manual?
Questions and answers