Yamaha 01X Supplementary Manual page 3

e From the pull-down list that appears, select "Yamaha
01X."
The Yamaha 01X will now be listed in the Remote
Devices folder.
r The next step is to specify the MIDI In and Out ports
for remote control operation.
Click on "Yamaha 01X" in the Remote Devices folder,
then click the arrow next to "MIDI Input" and select
the unnumbered mLAN MIDI In port. This corre-
sponds to Port 1, which should be used for the remote
control functions.
t Do the same for the MIDI Output parameter, selecting
the unnumbered mLAN MIDI Out port.
• For details on which mLAN MIDI port numbers are available for
the 01X, see page 95.
y When finished, click "Apply" to enter the changes, then
click "OK."
u Enable the 01X for remote control of Cubase SX 3.
Press the [UTILITY] button, then press knob 1 to call
up the REMOTE SELECT page. Press knob 3 to select
CUBASE/NUENDO, then press knob 8 (YES).
Finally, press the [REMOTE] button on the 01X panel
to enable the Remote mode (the button lamp lights).
Keep in mind that, unless indicated otherwise, the
Remote mode should be enabled throughout the
remainder of this section on using the 01X with Cubase
SX 3.
Recording/Playback/Remote Control
• Audio and MIDI setup
Since the mLAN connection serves not only as a control
surface for Cubase SX 3 but also as an audio and MIDI,
you'll need to make the appropriate audio and MIDI set-
tings in Cubase SX 3. Many of the necessary settings are
automatically made when you run the mLAN Auto Con-
nector (see the separate Installation Guide); this section
covers other important settings made after running Auto
Connector.
Audio setup
q From the Devices menu, select "Device Setup..."
w Select "VST Audiobay."
e Click the Master ASIO Driver pull-down menu, and
select "ASIO mLAN."
• For Mac OS X, select "mLAN Network."
01X Owner's Manual (Supplementary Manual)
67