Advertisement
Quick Links
60-120 min
Cutting Not
Required
Drilling Not
Required
Part List
www.tacautoparts.com
SIDEWINDER RUNNING BOARD
FITS:
Exclude：
Torque & Tools
Fastener
Tightening Torque
Size
(ft-lbs)
6mm
7-8.5
8mm
18-20
10mm
35-40
12mm
60-70
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
"27-L" for
Left/Driver Side
Driver/Left Side
Front Bracket
PART #: SW-T27
2010-Up Toyota 4Runner
2010-2013 4Runner SR5 Models
2010-Up 4Runner Limited Models
2020-2021 4Runner Nightshade Edition Models
2022-Up 4Runner TRD Sport Models
Wrench Required
Front
"27-R" for Right
/Passenger Side
Passenger/Right Side
Front Bracket
Driver/Left Side
Center/Rear
Bracket x2
Passenger/Right
Side Center/Rear
Bracket x2
Customer Support: tac-office@tacautoparts.com
Allen Wrench
Required
□ 10mm
■
13mm
□ 16mm
□ 18mm
□ 4mm
□ 5mm
□ 6mm
□ 8mm
Advertisement
Related Manuals for TAC SW-T27
Summary of Contents for TAC SW-T27
- Page 1 SIDEWINDER RUNNING BOARD PART #: SW-T27 FITS: 2010-Up Toyota 4Runner 2010-2013 4Runner SR5 Models 2010-Up 4Runner Limited Models Exclude： 2020-2021 4Runner Nightshade Edition Models 2022-Up 4Runner TRD Sport Models Torque & Tools Fastener Tightening Torque Allen Wrench Wrench Required 60-120 min...
- Page 2 8mm Lock Washer 8mm x 30mm 8mm Flat Washer 8mm x 25mm Hex Bolt Combo Bolt FIG 2 PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE DRIVER (2) 8mm Hex Bolts (2) 8mm Lock Washers SIDE INSTALLATION (2) 8mm Flat Washers STEP 1 Starting on the Driver/Left front of the vehicle, Front...
- Page 3 FIG 6 STEP 3 Move along the body panel to the center mounting location, (Fig 4). Select (1) Driver/Left Center/Rear Mounting Brackets. Attach the Mounting Bracket on center mounting location, (Figs 5 & 6). Do not tighten hardware. FIG 4 Front (Fig 6) Example of Driver/Left Center/Rear Mounting Bracket attached to the center location...
- Page 4 FIG 8 STEP 6 Level and adjust the Running Board and fully tighten all hardware. STEP 7 Rear Repeat Steps 1—6 to attach the Passenger/Right Running Board. (Fig 8) Example of Driver/Left Center/Rear Mounting Bracket attached to the rear location STEP 8 Do periodic inspections to the installation to make STEP 5...
Need help?
Do you have a question about the SW-T27 and is the answer not in the manual?
Questions and answers