Rampage Products 960134 Troubleshooting Manual

White for reverse light
(If applicable)
Bench Testing
Wire schematic
White for reverse light
(If applicable)
White
Ground
Brown
Running lamps
Yellow
Left turn/brake
Green
Right turn/brake
Rampage Products Light Bar Trouble Shooting Guide
Use wires to connect to plug connections
individually as shown. Ensure the appropriate
sections of the light bar work correctly.
Testing
By connecting the wires to the light bar off of the vehicle you can ensure the bar itself is
working correctly. If it
vehicle, check the connections on the vehicle or take to a qualified installer to review the
wiring on the vehicle. If one function specifically is missing be sure to check the plug
connections inside the vehicle plug. Clean and remove any corrosion then spray with
WD40 or a dielectric grease.
*NOTE: If the light bar has a red wire it must be connected to the + side of the battery or
power supply for the other functions to work.
Light bar
+ -
9V
works correctly during the bench test but not
Or 12 volt power source
off of vehicle.
when plugged into the