Philips Norelco NT3600/42 Troubleshooting

Troubleshooting & repair
My Philips Nose Trimmer does not work
If your nose trimmer is not working, the troubleshooting tips below may help you find a solution.
We recommend you follow the steps in the order listed below. In between steps, check to see if
the issue is resolved before moving to the next. Alternatively, you can watch the video below to
solve the issue.
1. Use the trimmer correctly.
Nose trimmers are built with a protective guard, such as the models with a cutting element on
each side, ensuring the blades will not be in direct contact with the skin. The protection guard
leaves short stubs of hair. It gives you a clean look without the risk of cuts, ingrown hairs, or hair
pulling.
Insert the trimmer into your nose. Rotate the trimming head to catch the hairs growing in
different directions. Do not insert the trimming head too far into your nostrils. For heads with a
rotary tip, insert it about 5 mm. For trimming heads with a linear tip, insert it approximately 12
mm. While rotating, you may hold the flat side of the trimmer against the skin to reduce any
tickling effect.
Always attach the eyebrow comb to the trimming head when trimming your eyebrows. The
comb allows you to cut the hair to the desired hair length.