BUSHWACKER BodyGear 14013 Manual

STEP 1 - PRIOR TO INSTALLATION
A) Bushwacker only approves installing the trail armor according to
these written instructions with the hardware provided. WARNING:
Failure to install according to these instructions will invalidate
the warranty. This includes, but is not limited to using alternative
installation methods, hardware, or materials. DO NOT USE: Loctite,
SuperGlue, or similar products on the hardware or the trail armor.
B) Fit: Verify the fi t of the trail armor to vehicle. (Some fi ling, sanding,
or cutting may be necessary to ensure proper fi t).
C) Painting: (Optional) if paint is desired it must be done prior to
installing trail armor on the vehicle. Clean outer surface with a good
grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface thoroughly
with a tack rag prior to paint. Application of plastic adhesion
promoter for TPO plastic as per your paint system manufacturer's
recommendations is required. Paint trail armor using a high quality
enamel, or polyurethane automotive paint.
D) Exhaust System: Modifi cations may be necessary to maintain
a minimum 4" clearance between trail armor and exhaust pipes.
(Exhaust gases should not vent directly onto trail armor)
E) Metal Protection: All exposed fasteners and bare metal should be
treated with rust resistant paint BEFORE installing trail armor.
F) Decals: Trail Armor may interfere with existing decals on vehicle. If
you wish, remove decals prior to installation of trail armor.
Included in Hardware Kit
1.
Alcohol Wipe,
2 pcs
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007
Jeep JK Trail Armor
Set Part #14013
Rev-1 03-11-10
Hood Protector & Tail Gate
TOOLS FOR EASY INSTALLATION:
•
Cleaning cloth
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
•
To claim a warranty, you must provide Proof
of Purchase.