BUSHWACKER BodyGear 14012 Manual

STEP 1 - PRIOR TO INSTALLATION
A) Bushwacker only approves installing the trail armor according to
these written instructions with the hardware provided. WARNING:
Failure to install according to these instructions will invalidate
the warranty. This includes, but is not limited to using alternative
installation methods, hardware, or materials. DO NOT USE: Loctite,
SuperGlue, or similar products on the hardware or the trail armor.
B) Fit: Verify the fi t of the trail armor to vehicle. (Some fi ling, sanding,
or cutting may be necessary to ensure proper fi t).
C) Painting: (Optional) if paint is desired it must be done prior to
installing trail armor on the vehicle. Clean outer surface with a good
grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface thoroughly
with a tack rag prior to paint. Application of plastic adhesion
promoter for TPO plastic as per your paint system manufacturer's
recommendations is required. Paint trail armor using a high quality
enamel, or polyurethane automotive paint.
D) Exhaust System: Modifi cations may be necessary to maintain
a minimum 4" clearance between trail armor and exhaust pipes.
(Exhaust gases should not vent directly onto trail armor)
E) Metal Protection: All exposed fasteners and bare metal should be
treated with rust resistant paint BEFORE installing trail armor.
F) Decals: Trail Armor may interfere with existing decals on vehicle. If
you wish, remove decals prior to installation of trail armor.
Included in Hardware Kit
1. 2.
Screw,
Clip,
12 pcs
12 pcs
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007
3.
Alcohol Wipe,
2 pcs
Jeep JK Trail Armor
Set Part #14012
Rev-2 03-11-10
Side Panels 4-Door
TOOLS FOR EASY INSTALLATION:
•
#2 Phillips Screwdriver
•
Cleaning Cloth
•
Marker
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
•
To claim a warranty, you must provide Proof
of Purchase.