Table of Contents
Advertisement
If you switch to PC and PC does not have sound while TV has it, please make
sure you have connected Line-In from W700F TV Box to Line-Out from your
computer.
How to add the missing channel
?
If there are some channels missing after Auto Scan, you can add the missing
channel to channel table by yourself from the steps below:
1. Please directly key-in the missing channel number by remote number pad.
2. Press "Menu" key to open the OSD menu.
3. Select the "TV" setting tab (the second from left).
4. Select "CH Add/Erase", and then pick "Yes" to add channel.
5. Now you can watch the missing channel.
TV picture is not clear?
TV signal could be reduced by the branching. Please make sure the cable
signal is good. Try to move the computer to a TV set and connect the cable
which is being used for the TV set. Also directly connecting the cable before
the splitter may help. This problem could also come from with static. Once you
connect the cable to our TV card, the static interfere the system. It's possible to
correct this problem by connecting a wire from the grounding of the cable to
ground. Also make sure computer grounding is good.
Why PIP does not work
?
Please make sure you have connected your computer VGA to W700F and
connect W700F to the monitor. For more information, please refer to the TV
box connection description.
If your display card of your computer has both DVI and VGA connected, please
make sure the settings in Windows is set to VGA output.
Please also check if your desktop resolution is one of our supported
resolutions. Please refer to the detail list of resolutions.
Contacting Compro Technical Support
Before you submit an email for support, please check the troubleshooting list
above. You may fill out the form (http://comprousa.com/en/form.htm) or directly
email to
support@comprousa.com
3GA0310429
16
Advertisement
Table of Contents
