COMPRO T500F - STARTUP Manual page 7

5. Connect the black socket of Power Up patch cable to the power switch
connector on the mainboard.
Double check your work. If you plug the cables into the incorrect pins, your
PC may not start or otherwise function improperly.
Connect the white end of the Power Up patch cable to the TV tuner card and
the black end to the mainboard.
Power Up Scheduling is not required for using VideoMate T500F PCI card. If
you don't want to use Power Up Scheduling from the Windows Shut down
state, you can skip the power switch circuit connections, in other words, you
can skip Power Up Connections in steps 3 through 6. You can still use
scheduled recording from Standby mode or powered on state.
7. Note: You may skip 7~9 if you select "Use PCI Audio" which can be found
at "System Device" tab under Options of ComproDTV.
8. Plug one end of the internal audio patch cable to the green Audio-Out port
on the VideoMate T500F PCI Tuner card.
9. Plug the other end of the internal audio patch cable to the AUX-In socket
on your sound card or on the mainboard. The on-board sound usually has
AUX-In and CD-In connector. Make sure you connect to the right one.
Then you have to choose the audio source to be AUX or CD-In in the
System Device in Settings of ComproDTV 4.
10. Verify that the power cord to your PC case is unplugged.
11. Insert VideoMate T500F PCI card in an open PCI slot. Compro
recommends installing the card in the third or fourth PCI slot away from the
AGP slot
6. Connect the white socket of Power Up
patch cable to the connector named
"JS2" on the VideoMate Vista T500F PCI
Tuner card.
Note
7