Hardware Installation - COMPRO T500F - STARTUP Manual

Hardware Installation

Unplug your PC's main power cord before installing VideoMate Vista
T500F PCI card. Failure to do so may cause damage to your VideoMate
T500F PCI card and void your warranty.
1. Shut down your computer and unplug main power cord.
2. Remove the computer case cover.
Power Up Connections
3. Locate the ATX power switch pins on
your computer case and trace the
wires to the power switch connector
on your mainboard. The ATX power
switch cable is normally a twisted
pair cable with a two-pin connector
as shown above.
On the mainboard, the ATX power switch pins are usually labeled "POWER
SW" or similar. It is vital to remember the position of these pins for a later step
in the installation process.
4. Unplug the ATX power switch cable from the
mainboard and connect it to the white
connector named "JS1" on the VideoMate
Vista T500F PCI card, as shown on the right.
6
Warning
Note