Related Manuals for STOKK E1 Series
Summary of Contents for STOKK E1 Series
- Page 1 Reverse Osmosis Water Filtration System E1 Series Thank you for choosing Stokk water filtration system. WWW.STOKKFILTER.COM...
-
Page 2: Table Of Contents
CONTENT PREPARATION BEFORE FIRST USE OPERATION CARE & MAINTENANCE TROUBLESHOOTING WARRANTY... -
Page 3: Preparation
PREPARATION The following instructions must be followed when using the product to prevent injury and property damage. Any incorrect operation due to disregard of instructions may cause harm or damage. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. -
Page 4: Product Specifications
In order to run the When not in use for an machine longevity, regularly machine smoothly, use extended period, shut off clean and replace the filters. Stokk filters and the water source and power accessories. supply and store the machine properly. PRODUCT SPECIFICATIONS... -
Page 5: Package Contents
3-6 months pH for tastier, healthier drinking water Mineral Filter The above is only an estimate due to the difference in feed water Note quality. Search "stokk+filter model" on amazon.com to purchase the correct replacement filter or purchase on www.stokkfilter.com... -
Page 6: System Features
SYSTEM FEATURES 0.85 (3.2L) Tap Water Tank Mineral Water Note Before starting use, please remove the activated Before starting use, please remove the activated carbon pouch from the Tap Water Tank. carbon pouch from the Tap Water Tank. PARTS DESCRIPTION Water Purifier Cover (Water Tank Control Panel... - Page 7 3/3 Pot Press「 」to dispense water in full bottle for glass carafe. 2/3 Pot Press「 」to dispense water in 2/3 bottle for glass carafe. 1/3 Pot Press「 」to dispense water in 1/3 bottle for glass carafe. Flush Press「 」to flush the RO filter for 30 seconds. Long press to enter the program of flushing the RO system and press any button to exit.
-
Page 8: Before First Use
BEFORE FIRST USE FLUSH THE RO SYSTEM If you are commissioning the system for the first time or have just replaced the filter cartridges, please follow the steps below 2-3 TIMES to ensure that the system gets adequately flushed before using.. Step 1 Always start the system flushing with a new tank of the potable (tap) - Page 9 Step 5 Changing Water - Empty the remaining waste water in the Tap Water Tank when the「 」indicator lights up, refill it with fresh water. Step 6 Repeat the steps 4-5 once or twice. Then you can enjoy fresh pure water.
-
Page 10: Water Dispensing
OPERATION WATER DISPENSING Alkaline Mineral Boost Carafe Before first use, remove the mineral filter, shake it a few Note times, soak it for 5 minutes, and then flush it with a carafe of water to activate the mineral filter. Place the provided glass carafe with mineral filter on the drip tray. Press「... - Page 11 Place a regular water cup on the drip tray. Press「 」,「 」or 「 」to dispense pure water. The TDS value(OUT) displayed on the control panel represents the Note TDS(Total Dissolved Solids) value of the purified water. Water with a TDS value below 50 ppm is safe for drinking. WATER CHANGING Why it prompts changing water while there is still water in one side of the tap water tank?
-
Page 12: Flushing System
FLUSHING SYSTEM Auto Flushing The water purifier will automatically flush after power supply, water change, or completion of water filtration. Manual Flushing Press「 」to flush the RO filter for 30 seconds. If not in use for an extended period, please flush the machine over 3-5 minutes following steps of Flushing System. - Page 13 Step 3. To replace the PPC or RO filter a. Lift the latch upwards to release the filter. b. Remove the original PPC or RO filter. c. Insert the new replacement filter into the circular port and push it into the correct position.
- Page 14 Step 4. Refill and replace the tap water tank and recover the water purifier cover. Step 5. Reset the filters. a. Plug in the power and long press「 」at least 5 seconds to enter the Filter Reset Program. b. Short press「 」to switch among “PPC-RO- C-”...
-
Page 15: Care & Maintenance
CARE & MAINTENANCE WARNING: Unplug the water purifier before cleaning. SYSTEM MAINTENANCE If you won't be using the system for more than a week, follow these steps: ·Before shutting down, drain the internal pure water tank and tap water tank. ·Store the system on a dry, secure surface away from direct sunlight in a room with ambient temperature. - Page 16 ·Fill the tap water tank with the descaling solution, place it back to the base and plug in. ·Press the 「 」 until one beep to enter manual flushing. The machine will flush for 30 seconds and stop. Repeat the manual flushing 5 times. ·Unplug the power and let it stand for 2 hours.
-
Page 17: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Solution E1 Code ·Continuous filtering water protection ·Unplug and re-plug the machine to ·Air enters the pipes, causing slow exit the protection mode. water production ·Remove and reinstall the RO filter. TDS shows 999 ·Electrical control error ·Unplug and re-plug the machine to ·Built-in TDS tester failure reset. -
Page 18: Faq
Q: What is an RO water purifier, and how does it work? A: The core component of a reverse osmosis water purifier is the RO membrane. It's a highly precise filter with a porosity of 0.0001 microns. Under pressure from the pump, the RO membrane allows water molecules to pass through while blocking dissolved salts (like sodium, potassium), heavy metal ions (such as lead, arsenic, mercury), organic compounds, and other contaminants. - Page 19 A:RO water is generally safe to drink. While the process does remove some minerals, water is not the primary source of minerals in our diet; most essential minerals are obtained from food. Additionally, Stokk RO systems include mineralization stages to reintroduce beneficial minerals back into the water.
-
Page 20: Warranty
WARRANTY TERMS & POLICY We warrant the highest quality in material, craftsmanship, and service for all our products, effective from the date of purchase throughout the warranty period. Defective products due to manufacturer flaws will be replaced based on eligibility. Refunds are available within the first 30 days of purchase and are applicable only to the original purchaser.
Need help?
Do you have a question about the E1 Series and is the answer not in the manual?
Questions and answers