Advertisement
PREPARATION
SCAN ME
Installation Guide
Do not install the filter on a water
supply pipe with a water pressure
exceeding 0.6 MPa. If the inlet water
pressure exceeds 0.6 MPa, please
install a pressure reducing valve.
For cold water line only.
Under Sink Water Filtration System
USER MANUAL
Warning: Please read it carefully before installation.
If you have problems during the installation process,
please contact our customer service.
support@stokkfilter.com
www.stokkfilter.com
+1(866)-387-8668 (Mon-Fri 10�00 AM-4�00 PM PST)
PROHIBITION
Do not freeze the filter, as
this can cause cracking
and water leakage.
ATTENTION
Turn off the water
supply while replacing
the filter.
Do not allow children under
3 years old to have access
to small parts during
installation of this product.
This installation must
comply with all applica-
ble state and local
regulations.
Advertisement
Table of Contents
Related Manuals for STOKK UR30-W
Summary of Contents for STOKK UR30-W
- Page 1 Under Sink Water Filtration System USER MANUAL Warning: Please read it carefully before installation. PREPARATION SCAN ME If you have problems during the installation process, please contact our customer service. support@stokkfilter.com www.stokkfilter.com +1(866)-387-8668 (Mon-Fri 10�00 AM-4�00 PM PST) Installation Guide PROHIBITION Do not install the filter on a water Do not allow children under...
-
Page 2: Parts Description
PARTS DESCRIPTION Bracket Filter head Teflon tape Inlet hose Filter cartridge Outlet hose 3/8'' - 1/2'' Converter Alignment pillar SPECIFICATIONS Precision 0.5-5μm Working Temperature 4-38°C/39-100°F Working Pressure 10-100 psi (0.7-6.8 bar) UC50: 1.6 gpm/6.06 lpm Flow rate UR30: 1.6 gpm/6.06 lpm UC50: 26000 gallons Filter Life Expectancy UR30: 16000 gallons... -
Page 3: Installation Tips
INSTALLATION TIPS Step 1. Installation of the filter system 1.Place the INSTALLATION TEMPLATE at the desire location with at least 2 inches of space between the bottom of the filter cartridge and the floor. Note: Mount the water filter at least 2 inches higher than the ground for easier filter change. 2.Drill through the holes marked on the INSTALLATION TEMPLATE with 1/4"... - Page 4 Step 2. Connect the water supply (Cold water only) 1. Shut off the water supply. 2. Remove the faucet hose. 3. Connect the outlet hose with faucet hose. 4. Connect the inlet hose to the cold water value. Note: If the original faucet is equipped with a male connector, resulting in disconnection, please contact our customer services.
- Page 5 3/8" angle valve outlet 1/2" angle valve outlet lf the cold-water supply valve is 3/8", it can be lf the cold-water supply valve is 1/2", it can be directly connected to the water supply. connected via the following two fittings. 1/2""outlet 3/8""outlet Connect ①...
-
Page 6: Filter Replacement
Step 3. Check the filter system lf water leakage occurs, turn off the water supply. 1. If the water leakage is at position ① or ②, wrap teflon tape on the external thread when connecting. 2. If the water leakage is at position ③ or ④, make sure insert the quick-connectfitting to the end. Kitchen Faucet Faucrt hose... -
Page 7: Frequently Asked Questions
Why didn't the TDS value lower after filtration? The main purpose of the Stokk filter is not to remove TDS. TDS stands for total dissolved solids, and it is basically composed of inorganic salts and a small amount of organic matter. - Page 8 1-YEAR QUALITY ASSURANCE All mechanical devices with moving parts have a normal lifespan and will need to be replaced periodically. Therefore, mechanical devices such as water fittings, filter heads, and faucets come with a limited replacement assurance of 1 year. We do not provide assurance on the service life of any filter cartridge, as it may vary depending on local water conditions and water consumption.
Need help?
Do you have a question about the UR30-W and is the answer not in the manual?
Questions and answers