Table of Contents
Advertisement
L4630BA(EN).fm Page 4 Thursday, June 15, 2006 3:42 PM
REAR PANEL
25
26
27
28
29
30
25.
RGB scart jack
AV-IN1: Connect to the scart jack of a DVD player or
set top box.
Table Stand
Tilt Stand
Adjust the stand to change the angle of TV
(-5°~10°).
PREPARATION FOR USE
Unpacking
The stand of this TV is folded when
you purchased. Place this TV face-
down on a flat surface covered with
the soft cloth. Bend the stand slowly
to forward until it clicks.
Do not bend from this side.
Connections
VHF
UHF
VHF/UHF
MIXER
RF cable (not supplied)
S-VIDEO input jack
26.
AV-IN2: Connect to the S-VIDEO output jack of a
video camera or VCR using the S-VIDEO cable (not
supplied).
Note:
The S-VIDEO jack is given priority over the
VIDEO jack.
27.
VIDEO input jack
AV-IN2: Connect to the video output jack of a video
camera, VCR or video game.
28.
AUDIO L/R input jacks
AV-IN2: Connect to the left/right audio output jacks of
a video camera, VCR or video game.
Note:
The AUDIO L (input) jack is for mono input.
The sound is heard from both speakers. Use this jack for
monaural audio equipment to be hooked up.
29.
Aerial input jack
Connect to an antenna, cable system or satellite system.
30.
Headphone jack
Connect headphone (not supplied) for personal
listening.
Note:
Do not connect earphones that have an L-shaped
plug. The plug may interfere with the cabinet.
5˚ 10˚
1)
Insert the RF cable plug into the
of this unit.
2)
Plug this unit into an AC outlet.
3)
The STANDBY-ON indicator on the front panel lights on, then
STANDBY-ON
press
turn the unit on.
PROG.
•
(
+/-
or
4
If you want to fold the stand again, insert
a thin rod into the hole in the right side of
the stand as illustrated, bend the stand
backward while you keep pushing the hole.
Aerial input jack at the back
on the front panel or the remote control to
/
) can also be used to turn the unit on.
EN
Advertisement
Table of Contents
