Vibrato - DigiTech STUDIOVOCALISTEX Manual

Vibrato

6. To edit the amount of Pitch Randomization, press the Right Arrow
button. Turn the Data Wheel to adjust to the desired value.
Adding Vibrato to the Studio Vocalist EX's harmonies is another way of
adding realism. Vibrato is the regular modulation of a voice's pitch that
lends interest to an otherwise static note. You can edit five different
vibrato parameters for each voice allowing you to construct the most
realistic vibrato performance possible.
Depth
This varies the amount of pitch deviation above and below the root pitch
of the harmony note. This varies in 1 cent increments between 0 and 100
cents.
Rate
This is the modulation speed of the vibrato. It is measured in Hertz (Hz:
the number of cycles per second). This can be varied in tenths of one Hz
between 0 and 9.9 Hz.
Type
This gives you a selection of four different vibrato waveforms. They are:
sine wave, square wave, sawtooth up and sawtooth down.
Delay
This changes the time between when the Studio Vocalist EX produces a
harmony note and the onset of vibrato. Vibrato does not immediately
occur after the delay period; instead it increases gradually in intensity. It
is edited in 20 millisecond increments from 0 to 2.5 seconds.
Randomness
Randomness applies random values to the combination of Depth and
Rate. Each new note you sing will have a slightly faster or slower vibrato
rate and slightly increased or decreased depth. This parameter is set from
1 to 10.
To edit the Vibrato parameters:
1. Use the Data Wheel to select the program you want to edit and press
the Edit button.
2. Press the softkey that corresponds to Vibrato. (Vibr)
3. Select a different style preset using the Data Wheel. If you are satis-
fied with loading a different style, refer to the "Storing your Edits"
section on page 30. Press the Edit button again to modify the cur-
rent Vibrato style or, to create a new Vibrato style from scratch, load
one of the blank styles (BlnkVibr #) and then press the Edit button.
4. To increase and decrease the Vibrato Depth on voice number one,
turn the Data Wheel. Press the softkeys below the LCD to select
21