Advertisement
Quick Links
Step-by-step instructions
Tools and supplies required: Pipe Thread Tape, Adjustable Wrench, Adjustable Pliers
1
Turn off the water supply to the sink before you begin making repairs. Remove the old Hose by unscrewing the
Threaded Connectors at the Spray Head and Faucet under the Sink. Next, examine the new Hose. The Round Nut
connects to the Spray Head, the Hex Nut connects to the female Quick Connector.
2
Install the new Guide in the Sink opening and tighten the Nut from the bottom of the Sink.
3
Unscrew the Nut from the Spray Head.
4
Push the hose through the Nut.
Advertisement
Related Manuals for Danco 88760
Summary of Contents for Danco 88760
- Page 1 Step-by-step instructions Tools and supplies required: Pipe Thread Tape, Adjustable Wrench, Adjustable Pliers Turn off the water supply to the sink before you begin making repairs. Remove the old Hose by unscrewing the Threaded Connectors at the Spray Head and Faucet under the Sink. Next, examine the new Hose. The Round Nut connects to the Spray Head, the Hex Nut connects to the female Quick Connector.
- Page 2 Snap the included Clip onto the Hose. Some Danco products use a larger clip to like the one shown to make it easier to attach. However, traditional smaller clips like this can also be used, depending on the type of clip that is included with your new Sink Spray.
- Page 3 While pulling back on the white collar on the Quick Connect Adapter, push the Quick Connect Adapter onto the Adapter Nipple on the Faucet connector. When fully seated, release the white collar. Tug the Hose to make sure the Quick Connect Adapter is secure. Turn the water supply on, run water and check for leaks.
Need help?
Do you have a question about the 88760 and is the answer not in the manual?
Questions and answers