The Rear Panel - DigiTech S100 User Manual

Section -1 Introduction
S-100

The Rear Panel

6 7
2 3 4 5 8
1
INPUT LEVEL LEFT/MONO RIGHT IN LEFT/MONO RIGHT OUT
POWER SUPPLY FOOTSWITCH MIDI IN
IN OUT
1) Input Level- This knob controls the level of signal entering the S-100. For optimal performance, set this level so the
Input level indicators (located on the front panel) occasionally light the red LEDs.
2) Left/Mono Input - This Input jack is used for the Left or Mono input. When only the Left input jack is used, the signal is
sent to both Left and Right S-100 inputs.
3) Right Input - This is the Right Input jack for the S-100 that when used with Left input will preserve stereo imaging.
4) Left/Mono Output - This is the S-100's left audio output. This output must be used if a mono effect
is desired.
5) Right Output - This is the S-100's right audio output. Use both left and right outputs to take
advantage of stereo effects.
6) AC Line Input - This is the AC adapter receptacle. Use only the included PS 750 power supply.
7) Footswitch Jack - This jack is used for the insertion of the Digitech FS-300 footswitch that will control program changes
and Bypass the digital effects of the S-100.
8) MIDI IN - This MIDI jack is used for receiving MIDI program change and CC information.
7
User Guide