DigiTech CONTROL SEVEN - MIDI Controller Pedal Manual

Also See for CONTROL SEVEN:

Owner's manual (2 pages)

Table of Contents

Contents

1 Introducing the Control Seven MIDI Controller Pedal
2 Pedal Description
3 Connection
4 Operation
- 4.1 MIDI Channel Select
- 4.2 Program Selection
5 Documents / Resources
- 5.1 Download manual

DigiTech CONTROL SEVEN - MIDI Controller Pedal Manual

Introducing the Control Seven MIDI Controller Pedal

The Control Seven MIDI Controller Pedal is a MIDI program change device, designed to provide a hands-free way to change programs on any MIDI device. The Control Seven transmits program changes 1-128 on MIDI channels 1-16.

Pedal Description

The Program Number/MIDI Channel display is a 4-digit LED display.

The pedals perform the program change and bank up/down functions. The back of the unit has a standard 5-pin DIN MIDI jack, and a 3.5mm Power In jack.

Connection

Plug in a MIDI cable to the MIDI OUT jack, and connect the other end of the cable to the MIDI IN on the device you want to control.
Plug in the AC power device to the Control Seven, and then to the AC outlet.

Operation

MIDI Channel Select

To select the operating MIDI channel, use the UP or DOWN pedals until a appears in the display. Use any numbered pedal to increment the MIDI Channel numbers. Once selected, press either the UP or DOWN pedal to exit MIDI Channel Select. For example, to select MIDI Channel 4, press the UP or DOWN pedal until the display reads . Press any numbered pedal until the display increments th , then press either the UP or DOWN pedal. The Control Seven will now transmit on MIDI channel 4.

Program Selection

The Control Seven operates in Banks of ten. The far right LED bars in the display indicate whether you are in the lower 5 or upper 5 programs in that bank. To choose a Bank, press either the UP or DOWN pedal. (MIDI Channel select is between 12 and 0). In a Bank, notice that either the lower bar or upper bar is lit in the display. Therefore, if the display reads 6, and the upper bar is lit, the programs selected will be 65-69.

When a program change message is sent out, the display will flash 4 dashes. To increment or decrement Banks quickly, press and hold the UP or DOWN switch. The numbers will change slowly at first, then scroll rapidly.

On power-up, the Control Seven defaults to MIDI Channel 1/Program Number 0. The Control Seven only transmits program change numbers 1 through 128, numbers 0 and 129 will not be transmitted.