curt 13113 Manual

13113
3/28/2011
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
Parts List
ITEM QTY PART NUMBER
1 7 M10-1.25 x 35
2 7 3/8"
HITCH WEIGHT: 29 LBS.
INSTALL TIME
30
PROFESSIONAL: MINUTES
60
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- LOWER EXHAUST REQUIRED
INSTALLATION STEPS
1) Temporarily lower muffler by removing rear rubber hanger.
2) Place hitch into position. Fit to inside and bottom of frame rails, one side at a time. Align
hitch with M10 weldnut in frame. (Note: Driver side should be positioned first.)
3) Install M10 fasteners - seven locations.
4) Torque all M10 fasteners to 38 lb.-ft. Re-attach rubber exhaust hanger.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
75214
MITSUBISHI ENDEAVOR
DESCRIPTION
HEX BOLT
CONICAL TOOTHED WASHER
DRIVER SIDE FRAME RAIL
EXISTING WELD NUTS (BOTH SIDES)
3,500 LBS. TRAILER WEIGHT &
5,000
LBS. TRAILER WEIGHT &
PASSENGER SIDE FRAME RAIL
2
1
350 LBS. TONGUE WEIGHT.
500 LBS. TONGUE WEIGHT
1-800-798-0813