Hover-1 i100 Manual

Hover-1 i100 Electric Hoverboard Scooter with
Infinity LED Wheel Lights
RECALIBRATE THE INTERNAL SENSOR OF THE
HOVERBOARD.
Please see below step by step instructions on how to recalibrate the
internal sensor of the hoverboard. This will help with the wheels
vibrating.
1) Place the board on a flat surface - make sure the board is completely
level
2) Starting with board powered off and unplugged from the charger,
press and hold the power button for 10-15 seconds - The headlights will
blink and the board will beep
3) Release the power button
4) Turn the board off and back on again. The calibration process is now
complete.
Please note that "If the board is tilted during calibration it will treat the
tilted position as the "start" position for the board."