Way Basics DOUBLE CUBE PLUS Manual

Cube, Cube Plus, and Rectangle Plus
DOUBLE CUBE PLUS
Peel adhesive strips
on vertical zBoards
Included
16 Pins 4 Vertical zBoards
adhesive strips on 2 edges
Double Cube Plus or Double Rectangle Plus
2 Backer Boards 2 Horizontal zBoards
thin and has no adhesive with groove on 1 side
1 Middle zBoard
with grooves on 2 sides
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
Important
Tip Start assembly from bottom to top.
Connect
DO NOT place unit on its side or back as
it will compromise its structural integrity.
With Us
Watch and Assemble www.waybasics.com/help-double-cube-plus
Place pins in each
vertical zBoards
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
1
Fit backboard into horizontal
zBoard groove.
5 Align vertical zBoard
to backboard.
talktous@waybasics.com
Align vertical zBoards
to horizontal zBoards
Triple Cube Plus or Tribeca
2
Carefully remove the 3M
protective layer from adhesive.
6 7
Align middle zBoard
(groove on 2 sides).
Help and Comments www.waybasics.com/contact
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry
3 4
Place alignment pins Arrange vertical zBoard with
in vertical zBoards. grooves facing backboard
as shown.
8
Repeat steps 1 - 5 for next tier.
Share Your Photos and Win
www.waybasics.com/share
Share and Win www.waybasics.com/share
Align horizontal zBoard and
press firmly to secure unit
together. Visit links below
for more details.
Enjoy building possibilities!