Table of Contents
Advertisement
To use QueGPS options:
1. Tap the QueGPS application tab or the Menu icon to display the
Options Menu.
2. Observe the list of options:
• Tap Preferences to display the GPS preference options.
• When in 2D mode, tap New Elevation to reset the elevation.
• Tap New Location when initializing the GPS Receiver if you
have moved over 600 miles from your last use location or if you
have not powered up the unit in over thirty days.
To use QueGPS preferences:
1. Tap the Preferences option to display the GPS Preferences Menu.
2. Observe the list of options with check boxes:
• Tap WAAS Enabled to enable the Wide Area Augmentation
System operating mode. (See Additional Information about
WAAS on page 57.)
• Tap Battery Saver to change the rate at which the GPS receive
updates your position data to conserve battery power. The GPS
receiver slows the frequency at which it calculates your location
and therefore requires less battery power with the result being a
slight loss in position accuracy. The GPS is turned completely Off
when the antenna is fully closed.
You cannot operate in the WAAS and Battery Saver modes at the
same time. If you attempt to check both boxes, a message will display
and the last option checked will remain on after you tap the
button.
OK
iQue 3600
GPS Applications
QueGPS Options
Select New
Location for
Initialization
Set New Elevation
Preference Settings
QueGPS Options
QueGPS Preferences Menu
5
Advertisement
Table of Contents
