Universal Remote Control Complete Control MRF-260 Installation Manual page 12

MRF-260 B S
ASE TATION
In the figure below, each device is set to a specific flasher.
Note: Remember, the MRF-260 will only respond to selections 1
through 4.
Step 5 - Make sure that the ID# is set on both the remote and on
the wheel of the MRF-260.
Click on the Receivers button and set the RF address to one of the
first 15 addresses (1-9 or A, B, C, D or E). The second set of address-
es is only supported by MSC units.
Step 6 - Close the RF window and Download to the Remote.
Page 9