Remington Ceramic 215, S1450 Manual

PRODUCT FEATURES

Before use, please read these instructions carefully and keep them in a safe place for future reference.

1. Ceramic coated plates
2. High heat 215°C
3. Ready to use in 30 seconds
4. Floating plate for superior alignment
5. On-off switch with LED indicator
6. 1.8m swivel cord
7. Multivoltage: For use at home or abroad. When used at 120V the heat up times and temperatures may vary.
   

• Due to the extreme heat capabilities of this styler, extra care should be taken when using.
• While heating, during use and cooling, place on a flat, smooth, heat-resistant surface. Only hold unit at the end of the handle.
• This is a high performance product, avoid frequent use to prevent damage to hair.
• Please note regular use of styling products may deteriorate the coating.
• Do not scratch the surface, as this will deteriorate the effectiveness of the coating.

CLEANING AND MAINTENANCE

Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.

SAFETY CAUTIONS

FOR ADDITIONAL PROTECTION THE INSTALLATION OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR ADVICE.

THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM. IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.

This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT IN USE.

• Do not leave the styler unattended when switched on.
• Allow the styler to cool down before storage.
• Do not immerse in water or other liquids.
• Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
• Always ensure the voltage to be used corresponds to the voltage stated on the unit.
• Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give explicit instructions or supervise the use of the appliance.
• Do not use any attachments with this styler, other than those supplied by Remington^®.

• Avoid allowing any part of the hot plates to contact the face, neck or scalp.
• Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
• This product is not intended for commercial or salon use.
• Damaged cords can be dangerous. If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorised Remington ® service dealer for repair or replacement in order to avoid a hazard.
• Special tools are required for any examination, adjustment or repair. Unqualified repair work could lead to hazardous conditions for the user.
• We do not accept responsibility for damage to the product, persons or other items(s), caused by misuse, abuse or non-compliance with these instructions.

WIRING INSTRUCTIONS UK Plugs Only

This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult a qualified electrician. The wires in the mains lead are coloured in accordance with following code:
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal which is marked 'N' or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked 'L' or coloured RED. Never connect either of the wires to the big EARTH terminal marked 'E' or coloured GREEN or GREEN AND YELLOW.