Rear Panel - Dynacord CMS 1000-3 Owner's Manual

3
CMS
HINT: The REC PEAK warning appears also when the DIGITAL AUDIO INTERFACE connected to a PC/Mac is used
for playback purposes only. In this case the warning can be ignored.
ACTIVE
The LIMIT indicator signals that the USB connection between CMS and PC/Mac is active and the DIGITAL AUDIO INTER-
FACE is ready for operation.

2.8 Rear panel

73 - M C
AINS ONNECTOR
The CMS receives its power supply via the lockable Mains input. Only the provided power cord may be used. Connect
the CMS only to a mains network, which corresponds to the requirements indicated on the type plate.
HINT: Press the yellow button at the plug to disconnect the power cord.
74 - POWER
Mains switch to turn the CMS on or off. The CMS is operational when the display indicates the selected program num-
bers. Please make sure to set the master faders to their minimum position or engage the STANDBY switch before switch-
ing the power on. This will save you, your audience, and the equipment from unnecessary stress. In case additional
external equipment is connected to the CMS – e.g. power amps, FX units, EQs, etc. – please, proceed in the following
order when switching your equipment on:
1. switch on the FX units
2. switch on the CMS
3. switch on external power amps
When switching the power off, please proceed in the opposite order.
75 - MIDI IN/OUT
The MIDI IN/OUT ports allow connecting MIDI devices to the CMS. Next to the PC MIDI interface controlling the effect
unit is possible via MIDI IN, please see page 27 for details.
24