Table of Contents
Advertisement
TOOLS NEEDED FOR DISASSEMBLY AND ASSEMBLY OF T GEARBOX
1.
Caulking Gun w/ #5900 Locktite
2.
Impact Wrench
3.
Ball Pin Hammer
4.
Torque Wrench
5.
Retaining Ring Pliers
6.
3/16" Punch
7.
10 mm & 14 mm Socket
8.
Locktite #270
BE CERTAIN TO CLAMP OR SECURELY SUPPORT THE GEARBOX AND SUB-
ASSEMBLIES TO PREVENT INJURIES TO HANDS AND FEET DUE TO INADVERTENT
DROPPING OR FALLING OVER.
ALWAYS WEAR SAFETY GLASSES AND GLOVES TO PREVENT EYE AND HAND
INJURY WHEN CHISELING OR HAMMERING ON METAL COMPONENTS. HARDENED
METAL WILL CHIP UN-EXPECTEDLY.
AN ASSEMBLED GEARBOX IS QUITE HEAVY. USE A HOIST OR GET HELP TO
HANDLE THEM SAFELY. LIFT CAREFULLY AND PROPERLY USING YOUR LEGS TO
LIFT - NOT YOUR BACK.
NOTICE: REFER TO OPERATOR'S MANUAL FOR INSTRUCTIONS FOR PROPER RE-ASSEMBLY ONTO
THE MOWER DECK. TIGHTEN CORRECTLY.
A96B 03/06
© 2006 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-12
Advertisement
Table of Contents
