Chapter Three: Setting Up On The Receiver; Preparation For Setup; Speaker Setup - Kenwood VR-4090 Instruction Manual

Chapter Three: Setting Up on the Receiver

It is possible to set up the speakers on the receiver main
unit.
However, some of the setting items such as the identifiable
device registration should also be set on Remote Control
unit. If setup is made on Remote Control unit, it is not nec-
essary to repeat any setup on the receiver side.
Therefore, it is recommended to perform setup on Remote
Control unit. This chapter describes the setup on the re-
ceiver only as an alternative method in case the setup is not
made on Remote Control unit.
Do not operate Remote Control unit during the receiver
setup.

Preparation for setup

Most of the receiver control keys are accommodated inside
the panel door. Make the following preparation for setup
on the receiver.
1. Plug the power cord into a household power outlet.
2. (VR-4090/VR-4080)
Press the REMOTE POWER key to turn the receiver ON.
(KRF-V7773D)
Press the POWER switch to supply the main power. The
receiver now enters the STANDBY mode (in which re-
mote control is available). Then press the ON/STANDBY
key to turn the receiver ON.
4. Open the panel door by pushing its lower part.
Panel door
Push the lower part of the
panel door.
Chapter Three: Setting Up on the Receiver
KEY LAYOUT
INPUT
A B
SPEAKERS
MODE

Speaker setup

1. Selecting the speakers
Selecting the SUBWOOFER:
1 Press the SET UP key inside the panel door to dis-
play "SUBWOOFER OFF (or ON)".
2 Press the MULTI CONTROL (fi/%) key to select
"ON" (when a subwoofer is used) or "OFF" (when
not).
Selecting the FRONT speakers:
3 Press the SET UP key to display "FRONT LARGE (or
NORMAL)".
4 Press the MULTI CONTROL (fi/%) key to select
"FRONT LARGE" (large-sized speakers) or "NOR-
MAL" (normal-sized speakers).
If the SUBWOOFER is set to "OFF", the FRONT
speakers are set automatically to "LARGE" and the
CENTER speaker selection display appears automati-
cally.
Selecting the CENTER speaker:
5 Press the SET UP key to display "CENTER NORMAL
(or LARGE or OFF)".
6 Press the MULTI CONTROL (fi/%) key to select
CENTER LARGE (large-sized speaker), NORMAL
(normal-sized speaker) or OFF (no center speaker).
If the FRONT is set to "NORMAL", the CENTER
speaker can be set to only either "NORMAL" or
"OFF".
fi % fi
CD 2/TAPE 2 LISTEN MULTI
P.CALL
MONITOR MODE SET UP SOUND CONTROL
Selecting the SURROUND speakers:
7 Press the SET UP key to display "SURROUND
LARGE (or NORMAL or OFF)".
8 Press the MULTI CONTROL (fi/%) key to select
"SURROUND LARGE" (large-sized speakers), "NOR-
MAL" (normal-sized speakers) or "OFF" (no sur-
round speaker).
When the FRONT is set to "NORMAL", the SUR-
ROUND speakers can be set to only either "NOR-
MAL" or "OFF".
Selecting SW RE-MIX:
9 Press the SET UP key to display "SW-REMIX OFF (or
ON)".
0 Press the MULTI CONTROL (fi/%) key to select
"ON" or "OFF".
- Press the SET UP key to proceed to "Agjusting the
speaker volumes" below. To exit from setting, press
the SET UP key repeatedly until "SETUP FIXED" is
displayed.
If the SUBWOOFER is set to "OFF", this step is
skipped. For details on the SW RE-MIX and the se-
lection of speakers, please see page 36.
%
MEMORY AUTO BAND
43
Continued to next page