Chapter Tree : Setting Up On The Receiver - Kenwood VR-4900 Connection And Setup Manual

Chapter Three: Setting Up on the Receiver
It is possible to set up the speakers and register the input
devices on the receiver main unit.
However, some of the setting items such as the controlled
device registration should also be set on the PowerTouch.
If setup is made on the PowerTouch, it is not necessary to
repeat any setup on the receiver side.
Therefore, it is recommended to perform setup on the
PowerTouch. This chapter describes the setup on the receiver
only as an alternative method in case the setup is not made
on the PowerTouch.
Do not operate the PowerTouch during the receiver setup.
Preparation for setup
Most of the receiver control keys are accommodated inside
the panel door. Make the following preparation for setup
on the receiver.
1. Plug the power cord into a household power outlet.
2. (VR-4900, VF-4700)
Press the REMOTE POWER key to turn the receiver ON.
(KRF-V9993D)
Press the POWER switch to supply the main power. The
receiver now enters the STANDBY mode (in which re-
mote control is available). Then press the ON/STANDBY
key to turn the receiver ON.
3. Open the panel door.
VR-4900/KRF-V9993D VR-4700
Press the DOOR OPEN/
CLOSE key to open the
panel door. To close it, press
the key again.
Panel door
Panel door
Chapter Three: Setting Up on the Receiver
Key layout
A
SPEAKERS
Speaker setup
1. Selecting the speakers
Selecting the SUBWOOFER:
1 Press the SET UP key inside the panel door to dis-
play "SUBWOOFER OFF (or ON)".
2 Press the MULTI CONTROL (fi/%) key to select ON
(when a subwoofer is used) or OFF (when not).
Selecting the FRONT speakers:
3 Press the SET UP key to display "FRONT LARGE (or
NORMAL)".
4 Press the MULTI CONTROL (fi/%) key to select
FRONT LARGE (large-sized speakers) or NORMAL
(normal-sized speakers).
If the SUBWOOFER is set to OFF, the FRONT speak-
ers are set automatically to LARGE and the CENTER
speaker selection display appears automatically.
Selecting the CENTER speaker:
5 Press the SET UP key to display "CENTER LARGE
(or NORMAL or OFF)".
6 Press the MULTI CONTROL (fi/%) key to select
CENTER LARGE (large-sized speaker), NORMAL
Press the lower part
of the panel door.
(normal-sized speaker) or OFF (no center speaker).
If the FRONT is set to NORMAL, the CENTER speaker
can be set to only either NORMAL or OFF.
Selecting the SURROUND speakers:
7 Press the SET UP key to display "SURROUND
LARGE (or NORMAL or OFF)".
fi %
I NPUT CD 2/TAPE 2 LISTEN MULTI
B
MODE MONITOR MODE SET UP SOUND CONTROL
fi %
P.CALL MEMORY AUTO BAND
8 Press the MULTI CONTROL (fi/%) key to select
SURROUND LARGE (large-sized speakers), NOR-
MAL (normal-sized speakers) or OFF (no surround
speaker).
When the FRONT is set to NORMAL, the SUR-
ROUND speakers can be set to only either NORMAL
or OFF.
Selecting SW RE-MIX:
9 Press the SET UP key to display "SW-REMIX OFF
(or ON)". If the SUBWOOFER is set to OFF, select-
ing SW RE-MIX step will be skipped.
0 Press the MULTI CONTROL (fi/%) key to select ON
or OFF.
- Press the SET UP key to proceed to "Selecting the
speaker volumes" below. To exit from setting, press
the SET UP key repeatedly until "SETUP FIXED" is
displayed.
For details on the SW RE-MIX and the selection of
speakers, please see page 36.
43