Subscribe to Our Youtube Channel
Related Manuals for Unox XEBPC-08EU-V
Summary of Contents for Unox XEBPC-08EU-V
- Page 2 PROVERS...
- Page 4 - If the appliance is installed on a mobile base or stacked, only use components supplied by UNOX, and follow the assembly instructions provided in the packaging. For further details, go to the “Warranty” section on the website www.unox.com...
- Page 5 Do not remove, damage or modify the plate. - Failure to follow these instructions may cause damage, injury or death; voids the warranty*; and relieves UNOX of all liability. SAFETY REGULATIONS FOR USE - Following any procedures other than those indicated in...
- Page 20 Checks For proper electrical connections, the appliance must: - The copper jumper on the termi- - Be wired into an equipotential nal board and the electrical cable system in accordance with cur- must be fastened together under rent regulations. This connection the screw in its tightening direc- tion, and the electrical connec- must be performed between dif-...
- Page 22 Cl- ≤ 10 ppm (2 drops of reagent*) UNOX.Pure NHM = 450 – 500 μS/cm Cl- > 10 ppm (2 drops of reagent*) UNOX.Pure-RO NHM ≥ 500 μS/cm UNOX.Pure-RO * use the reagent in the UNOX KSTR1081A kit ** hardness measured using the UNOX KSTR1082A kit...
- Page 28 PROVERS...
- Page 34 Cleaning the prover cavity and the drain tray Before cleaning the prover cavity, make sure that all parts of the appliance have reached room temperature. Make sure the drain tray is under the prover Remove the cap from the bottom of the prover cavity Open the prover door by about 5 cm Turn the prover on and set the humidity to 0% and the temperature to 50°C...
Need help?
Do you have a question about the XEBPC-08EU-V and is the answer not in the manual?
Questions and answers