Brother DCP-L1640W Quick Setup Manual

D03AN5001-00
Version 0
EN
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies.
A5 Paper Long Edge
Support
1
Remove the packing materials and install the toner cartridge
Drum Unit (Remove the drum unit)
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back
Quick Setup Guide
DCP-L1640W / DCP-L1642W / DCP-L1642WXL / DCP-L1660W
UK
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available on the Brother support website:
support.brother.com/manuals
Toner Cartridge
(DCP-L1642WXL only.
Quick Setup Guide Product Safety Guide
For the long edge of A5 paper
Front
NOTE:
• The components included in the box may differ depending on your country.
• The available connection interfaces vary depending on the model.
If you use a wired connection, you must purchase the correct cable for the
interface you want to use.
• USB cable
Toner Cartridge
Replacement
• Network cable
Save for later use.)
• The screens and images in this Quick Setup Guide show the DCP-L1642W.
• Brother aims to reduce waste and save both raw materials and the energy
required to produce them.
Read more about our environmental work at www.brotherearth.com.
• Save all packing materials and the box in case you need to ship your machine.
Make sure the printing
surface is face up.
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
Use a straight-through Category 5 (or greater) twisted-pair cable.
Adjust the paper guides to fit the
paper being used.
4 Select your country/language
(Initial setup only)
After turning the machine on, you may be required
to set your country or language (depending on your
machine).
If required, follow the on-screen instructions.