Brother DCP-L1630W Quick Setup Manual

D033J5001-00
OCE/ASA/SAF/GLF
Version 0
EN
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies.
1
Remove the packing materials and install the toner cartridge
Drum Unit (Remove the drum unit)
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back
Quick Setup Guide
DCP-L1630W / DCP-L1632W
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available on the Brother support website:
support.brother.com/manuals
Toner Cartridge
Quick Setup Guide
For the long edge of A5 paper
Front
A5 Paper Long Edge
Support
Product Safety Guide
Make sure the printing
surface is face up.
Adjust the paper guides to fit the
NOTE:
• The components included in the box may differ depending on your
country.
• The available connection interfaces vary depending on the model.
If you use a wired connection, you must purchase the correct cable for
the interface you want to use.
• USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more
than 2 metres long.
• Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable.
• The screens and images in this Quick Setup Guide show the
DCP-L1632W.
• Save all packing materials and the box in case you need to ship your
machine.
paper being used.
4 Select your country/language
(Initial setup only)
After turning the machine on, you may be required
to set your country or language (depending on your
machine).
If required, follow the on-screen instructions.