Perlick PKHT24A Quick Setup Instructions

PKHT24A
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
qualified service technician and
comply with all available Federal,
State and Local Health, Electrical,
Plumbing and Safety codes.
NOT MORE
THAN 22"
HEIGHT FROM
FLOOR
STEP
1
1"AIR GAP
WALL
DRAIN
Connect the drain hose to wall, not higher than
22 inches, or floor drain. The drain hose should
have a 1 inch air gap between drain hose and
drain.
STEP
3
Connect dishmachine to hot water source,
recommended minimum temperature 140°F. Unit will
remain in wash cycle until booster heater
temperature reaches 180°F, then it will advance into
rinse cycle.
1
DRAIN HOSE
GROUND
HOT
HARD WIRE
THREE WIRE
POWER SUPPLY
1/2" WATER INLET
FLOOR DRAIN
PKHT24A REAR VIEW
3
PUMP DRAIN
MOTOR
2 LEVELING
LEGS
4
STEP
Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
4
STIFFENER
RINSE
INJECTION
CHEMICAL
TUBING
DETERGENT
INJECTION
RED
WASH
SENSOR
RINSE
SENSOR
STEP
2
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back and
side to side.
BLUE
RED
TUBE
BLUE