Table of Contents
Related Manuals for HP SCSI
Summary of Contents for HP SCSI
- Page 1 HP SCSI Hard Disk Drive Installation Guide HP SCSI-Festplattenlaufwerk Installationshandbuch Unité de Disque Dur SCSI HP Guide d’installation Unidad de Disco Duro SCSI de Guía de Instalación Léase esto primero Unità a Disco Rigido SCSI HP Guida di installazione...
- Page 2 Hewlett-Packard Company. Hewlett-Packard no asume responsabilidad alguna por el uso y fiabilidad de su hardware o software en equipos que no hayan sido creados por HP o equipos para los cuales no se haya probado. Avviso Le informazioni presenti in questo documento sono soggette a modifica senza preavviso.
- Page 3 Installing Your HP SCSI Hard Disk Drive...
-
Page 4: Installing The Hard Disk Drive
HP SCSI Hard disk refer to the Technical Information which accompanies your product. Supported Platforms To find out on which PC’s you can install HP SCSI Hard Disk Drive go to the following HP Web site: www.hp.com/go/pcaccessories... - Page 5 NOTE If your PC does not support SCSI Plug-and-Play , you should note the SCSI IDs that are already in use before switching off your PC. Your PC should indicate at Startup those IDs that are currently in use. When you have all the necessary materials to hand: 1 Turn off your PC and display, and disconnect all cables and power cords.
- Page 6 SCSI ID for each hard disk drive. If you intend to use your new HP SCSI in a multi-disk Fast RAID configuration with an existing disk drive, you must: 1 Verify that the capacity and media rotation speed of all disk drives to be used in the Fast RAID configuration are the same.
- Page 7 2 Set your new SCSI hard disk drive’s ID to one not already in use. Your SCSI hard disk drive is set to SCSI ID 0 by default, a device ID normally reserved for bootable hard disk drives. If this is the first SCSI device to be installed in your PC, do not change the SCSI ID.
-
Page 8: Step 4: Inserting The Hard Disk Drive
CAUTION Your SCSI hard disk drive needs adequate space and cooling. If you are installing your hard disk drive into an HP Kayak XU or XW PC Workstation, you must install your hard disk in either the lower or upper internal shelf. Do not attempt to install your hard disk drive in a 5.25-inch front access shelf. -
Page 9: Troubleshooting
• each SCSI device is assigned a unique SCSI ID • the SCSI ID 0 is assigned to the bootable hard disk drive. • your internal SCSI cable is terminated • the settings of the Ultra SCSI single-ended and Ultra2 SCSI support jumper (some models only) Refer to “Steps 1 to 3”... -
Page 10: Hardware Warranty
If this accessory is purchased and used together with an HP Brio or HP Vectra PC, or an HP Kayak Workstation, it will be covered by the warranty of this computer or workstation, under the same conditions of service and duration. - Page 12 Avoid Striking the Computer Stoßen Sie nicht an den Computer Evitez de heuter l’ordinateur Evite golpear el computador Non dare colpi al computer Don’t move the PC when powered on Verändern Sie nicht die Position des PC, wenn er eingeschaltet ist. Ne déplacez pas l’ordinateur lorsqu’il est sous tension No mueva el PC cuando esté...
Need help?
Do you have a question about the SCSI and is the answer not in the manual?
Questions and answers