Kurgo Backseat Bridge Manual

Kurgo Backseat Bridge Manual

Advertisement

Kurgo Backseat Bridge Manual

Product Overview


These products prevent dogs from getting into the front seat where they can interfere with the driver and cause distracted driving accidents. They do this either as a physical barrier to the front seat or as a restraint to keep pets from roaming around in the car.

Product Overview

  1. Bridge platform
  2. Seat strap
  3. Seat strap D-ring
  4. Center console barrier
  5. Headrest strap
  6. Headrest strap D-ring
  7. Cup holder
  8. Barrier pocket

Installation

Installation

  1. Open the Backseat Bridge and lay it flat across the backseat of the vehicle with the preferred color facing up. Slide the bridge forward until the edge with the center console barrier is flush against the back of the front seats. Place on top of any front seat divider if needed, to ensure any gap between the platform and front seats is closed.
    warning NOTE: The space between the back of the front seat and backseat edge should be 13" or less.
  2. Secure seat strap (B) around the back rest of your driver's seat, as close to the bottom of the seat as possible, and clip it to the seat strap D-ring (C). Repeat on your passenger's side.
    warning NOTE: Seat strap D-rings (C) are located on both sides of the bridge. Connect the seat straps to the D-rings located on the underside of the Backseat Bridge, based on your preferred color choice being right side up.
  3. Pull headrest strap (E) around your driver's side headrest and clip onto the headrest strap D-ring (F). Repeat this on the passenger side.
  4. Adjust all straps for a secure fit.

Additional Tips

information

  • Continuous adjustment of the front seats may damage the bridge
  • The center console barrier (D) cannot hold up to sustained pressure. Please discourage your pup from resting their head, or putting their paws on the center console barrier (D).

informationTRAINING TIPS
HARRISON SAYS...

Some dogs are overly excited to travel, making in and out of the car potentially dangerous. If they understand 'stay' this issue can be avoided. I suggest practicing on a leash; opening the car door and rehearsing 'sit' or 'stay' commands. Once stationary for a short time you can give your pup an assertive 'OK' command, letting him know it is safe to get in or get out. Make sure to always praise him when everything is done correctly.

Cleaning Instructions

Our product cleaning instructions will help ensure that your gear has a long, exciting life. Washing by hand and hang air-drying is the best way to care for your Kurgo products.

Hand Wash Instructions

  1. Brush off loose dirt with a dry brush.
  2. Spot clean with a damp sponge, cold water, and mild soap. Avoid harsh detergents.
  3. If necessary, rinse larger area to eliminate excess soap residue.
  4. Hang or lie flat to air dry (do not machine dry).

warning NOTICE: Please contact Kurgo directly with any product or warranty inquiries.

Kurgo Products

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Kurgo Backseat Bridge Manual

Advertisement

Need help?

Need help?

Do you have a question about the Backseat Bridge and is the answer not in the manual?

Questions and answers

Table of Contents