The Command Menu - CYBEX AUTOVIEW COMMANDER Installer/User Manual

The Command
Menu
Once you have activated the main OSD Window, you can open the Command
Menu by either pressing the Control key twice or by typing ALT-M.
The Command Menu options are selected in the same manner as channels
in the OSD Window. Scroll the Highlight Bar up and down and press Enter
when your selection is highlighted.
If you are operating in non-secure mode or are the system administrator,
you will have several options that do not appear in the User level Command
Menu: Channel Maintenance, Administrator Functions and Sequential
Scan Dwell Time. Channel Maintenance and Administrator Functions are
both covered in separate sections in this chapter. Scanning is covered in
Chapter 5.
If you experience a loss of mouse signal while using the AutoView, select
the 'Reset Standard Mouse/Keyboard' option from this menu for a PC with
a standard mouse driver or 'Reset Wheel Mouse/Keyboard' if you are using
a PC with a Microsoft IntelliMouse driver. This will reset and in most cases
restore your mouse signal. These commands are equivalent to the
<CM>MR<Enter> and <CM>MW<Enter> keyboard command listed in
the 'System Control & Maintenance' section of this manual.
Choose the option 'Version Information' to display on your monitor the
current version level of your OSD firmware. Press the Esc key to clear this
information from your screen.
Program Manager
Cybex Control Panel
Administrator Command Menu
Channel Maintenance
Administrator Functions
Turn Scanning ON
Scanning Order
Sequential Scan Dwell Time
Reset Standard Mouse/Keyboard
Reset Wheel Mouse/Keyboard
Version Information
Games
ENTER-accept ESC-previous

THE COMMAND MENU

15
On-Screen Display Operations