Solight KP12 Manual

EN KP12
Convector
Thank you for purchasing our equipment. Please read this manual carefully and heed the safety warnings and instructions before
installing, using or repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.
TECHNICAL PARAMETERS
Power input
Power
Dimensions
Coverage
Cable length
The device has an adjustable thermostat, overheating protection and the possibility of placing it on the wall or standing. Heating
element: Aluminum X-sharp type.
DESCRIPTION OF
1. Rear panel
2. Control panel
3. Temperature control knob
4. Waterproof power switches (1000W/2000W)
5. Front panel
6. Wheels
INSTALLATION
A) Installation on the ground with feet
1. Turn the device over and screw on the feet.
2. Place the device in the desired location and plug the power cord into a power outlet.
B) Installation on the wall
When wall mounted, the unit must be: at least 200mm above the ground, 500mm from the ceiling, and
200mm on the sides to allow for proper air circulation.
Pay attention to the distance between the device and other objects
It is forbidden to install the device under the socket. The device is IPX4 rated, meets the safety standard and can be installed in any
room, including the bathroom.
By hanging up
1. Measure the hanging distance according to the holes on the back of
the device.
2. Insert dowels into the pre-drilled holes
3. Screw on both slotted brackets
4. Mount the device on the slotted brackets. There are holes on the rear
panel for mounting.
5. Plug the power cord into a power outlet
6. Switch on the device
By drilling
1. Screw the bracket to the bottom of the device on both sides
2. Insert the dowels into the pre-drilled holes and screw the bracket to the wall.
3. Plug the power cord into a power outlet
4. Switch on the device
NOTE: If you are installing the device in the bathroom, we recommend installing it in a place where it cannot be touched once you
are in the bath or shower!
220-240V, 50Hz
1000/2000W
730x260x480mm
IPX4
160cm
Holder for hanging
Honeycomb
Bolts
Bracket for
drilling