Solight KP10 Manual

EN KP10
Fan heater 2000W
Thank you for purchasing our equipment. Please read this manual carefully and heed the safety warnings and instructions before
installing, using or repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.
SAFETY NOTICE
When using electrical appliances, basic safety precautions should always be observed to reduce the risk of fire, electric shock and
personal injury, including the following. For your own safety and proper use, read the following information carefully before using
the appliance for the first time.
- The device is not intended for children. It can only be used under adult supervision.
- If the power cord or the device is damaged, do not use the device. Repairs may only be carried out by the manufacturer's service
centre.
- Prevent objects from entering the ventilation or exhaust opening. Do not cover any part of the equipment.
- Do not place the appliance directly under the socket.
- Do not use this device in the immediate vicinity of a bath, shower or swimming pool.
- Do not use the device if it is damaged.
- Use the device only on a stable, level surface.
- Do not use the device in rooms that are occupied by people who are unable to leave the room independently.
- Do not use the device near animals unless they are under constant supervision.
- To reduce the risk of fire, keep fabrics, curtains or any other combustible material at least 1m away from the air outlet.
- Some parts of this product can be very hot and cause burns.
- Do not use the device with an external timer or other external device that automatically turns it on or off.
- Always operate the equipment from a power source with the same voltage, frequency and rating as shown on the product
identification label.
- Before use, remove the device from its packaging and check that it is in good condition.
- Be sure to turn off the power before disconnecting the power cord. Make sure to keep your hands dry when touching the unit to
avoid electric shock.
- Before use, make sure the power cord is fully extended and positioned so that it does not touch any part of the heater.
- Some parts of the device are hot when in use. When carrying, hold the heater by the handle only.
- Do not use the device in areas such as garages where gasoline, paint or other flammable substances are used or stored.
- Place the device in a suitable location with a clear space of approximately 1 m on all sides.
- Do not place the cable under the carpet or cover it with carpet or furniture. Arrange the cable so that it cannot be tripped over.
- Do not expose the product (and its cable) to damp or wet environments.
- This product must not be used in the immediate vicinity of water such as a bathtub, sink, etc. where immersion or splashing may
occur.
- A common cause of overheating is deposits of dust and fluff entering the heater. Ensure these deposits are removed regularly by
unplugging the heater, allowing it to cool and cleaning it as described in the Maintenance section.
- Make sure that no other high-current appliances are connected to the same circuit as the heater, as overloading may occur.
- Do not use an extension cord as it may overheat and cause a fire hazard.
- The device can only be used indoors. Use of the equipment outdoors is strictly prohibited.
- When the device is switched on, do not leave it unattended.
- Do not place any objects on the equipment, do not allow objects to cover inlet or outlet openings, or work in close proximity to
walls or curtains, etc. Do not cover the equipment during operation.
- Do not modify or repair the equipment in any way. Repairs may only be carried out by the manufacturer's service centre.