Table of Contents
Advertisement
Quick Links
EN
KP07
Wall mounted ceramic
heater
Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely
and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the
electrical appliance usage guidelines. Keep the instruction manual carefully. For use in the home or indoors. This product should only be used
by an adult.
TECHNICAL PARAMETERS
Power - 1100 W, 2000 W
Power supply - 220-240V, 50Hz
Protection - IP22
Power levels - 2
ASSEMBLY
Drill two holes in the wall at a distance of 1.8 m from the ground. The diameter of the hole must be the same as the dowel. After the dowel
has been inserted, fix the hook into the dowel. Make sure the hook is secure and hang the heater. The clip under the hook should be
inserted into the bottom of the heater.
CONTROL
Control panel
CONTROL VIA DISPLAY
1. Plug the device into a power outlet and turn it on by pressing the red 0/I switch, the device will enter standby mode and the display
will show:
2. Pressing the
button 1x - starts the fan mode (Fig.
Pressing the
button 2x - starts the low heating mode (Fig. B)
Pressing the
button 3x - starts the heating mode (Fig. C)
Pressing the
button 4x - enters standby mode and the display shows "--" (as in Fig. A). The fan will run for 30s and enter standby
mode.
Remote control
LED display
Control
button
Remote
control
receiver
Area of functions
Settings and
confirmation area
Area of
programmes
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Solight KP07
Summary of Contents for Solight KP07
- Page 1 KP07 Wall mounted ceramic heater Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the electrical appliance usage guidelines.
- Page 2 3. After starting the device, press the " " button and the device will enter the working state. Use the buttons on the controller " " to set the desired temperature. Or set one of the two heating modes on the display. To start the countdown (1-12h) press the button "...
- Page 3 Temperature setting In operating mode, press " " , the display will show "23" as the default temperature. Press " " to set the desired temperature (10-49°C can be set). Press " " to confirm the setting. Example of setting: The current ambient temperature is 15℃, when the temperature is set to 25℃, the display will show the following: WEEKLY PROGRAM SETTINGS 1.
- Page 4 The product has been issued with a CE declaration of conformity in accordance with the applicable regulations. On request from the manufacturer: info@solight.cz, or download at www.solight.cz At the end of its useful life, the equipment must be disposed of at a designated place. Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Czech Republic.
Need help?
Do you have a question about the KP07 and is the answer not in the manual?
Questions and answers