Larson Electronics EPLC2-48-100LED-SFC Instruction Manual

Surface Mount Explosion Proof Linear LED light
This explosion proof light is designed for illumination of industrial locations. It uses the latest in
solid state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HID luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 120-277V AC 50/60 Hz power supply without any variation in light output.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires' voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
MOUNTING
Mount and wire in a manner that meets all applicable NEC and local codes.
Attach bracket to light fixture using the included hardware. There are two main bolts to hold the
bracket in place, one bolt for each side. Additional set screws lock the bracket in place when
mounting at various angles. Simply align the bracket to one of the side holes and install set screw. It
may be necessary to install bracket to surface first, then attach light to bracket depending on
mounting method.
It is recommended to have at least two qualified technicians install this fixture as it can be difficult to
handle while mounting.
Install fixture to flat surface that can structurally support the load. Adjustment points on each side can
be loosened to adjust the angle of the light.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
EPLC2-48-100LED-SFC
www.larsonelectronics.com 1 of 2