Sealey VS7030.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
‰
WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
‰
Ensure that the kit is correct for the task.
9
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
9
DO NOT use a workshop press to fit GEN2 wheel bearings.
8
DO NOT fit a wheel bearing with a damaged retaining ring.
8
DO NOT use the kit for any purpose other than that for which it is designed.
8
DO NOT use air tools with this kit to remove/install bearings.
8
Always keep force screw well lubricated.
9
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
8
After use, store in a safe, dry childproof area.
9
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish the current
▲
procedure and data.
WARNING: The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur.
‰
It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
2. INTRODUCTION
Designed for the second generation of wheel bearing found on modern vehicles. These bearings are lightweight with an integral
mounting flange. They are also pre-loaded with a retaining ring that secures the bearing into the housing. Suitable to be used in
situ when replacing the front wheel bearings. Supplied in storage case.
3. SPECIFICATION
Model no: ..................................................... VS7030.V2
Bearing size: ........................................................ 78mm
© Jack Sealey Limited
78MM FRONT WHEEL BEARING GEN2 REMOVAL/
INSTALLATION KIT, FORD/MAZDA/VOLVO
VS7030.V2
MODEL NO:
Original Language Version
VS7030.V2 Issue:2 04/10/24