Pppoe (Dsl) - D-Link DIR-625 - RangeBooster N Router Wireless User Manual

Section  - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
My Internet
Select PPPoE (Username/Password) from the drop-down menu.
Connection:
Address Mode:
Select Static if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in the next
box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection Mode:
Select either Always-on, On-Demand, or Manual.
Maximum Idle Time:
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE
only).
DNS Addresses:
Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature,
enable Auto-reconnect.
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is
the default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC's
MAC Address button to replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-65 User Manual
Internet Setup

PPPoE (DSL)

1