Summary of Contents for LifeSpan Kids Lynx Metal Swing Set
Page 1
USER MANUAL Lynx Metal Swing Set Find the Digital Manual Online WARNING: The disassembled product may contain small parts which pose a choking hazard to children under 3. IMPORTANT: This product may contain sharp points and small parts prior to assembly. The owner’s manual contains safety, assembly, use and maintenance instructions.
TABLE OF CONTENTS I. GENERAL SAFETY INSTRUCTIONS 1.1 Danger for Children 1.2 Risk of Injuries 1.3 Product Damage 1.4 Assembly Advice II. SAFETY INSTRUCTIONS III. SWING SET ASSEMBLY IV. ANCHORING V. MAINTENANCE VI. CLEANING VII. WARRANTY...
I. GENERAL SAFETY INSTRUCTIONS This product is intended for outdoor domestic use only. Weight Limit: 50kg per apparatus Maximum Fall Height: 1.83m 1.1 DANGER FOR CHILDREN WARNING: No eating while using the product. • Children do not recognize potential dangers from this product. The product must be stored out of reach of children and pets.
1.4 ASSEMBLY ADVICE • The assembly of the product must be done carefully and by an able-bodied adult. If in any doubt, ask a technically qualified person. • Before you start with the assembly, read the instructions carefully. • Remove all packaging materials and lay down all parts on an open space. This gives you an overview and simplifies the assembly procedure.
II. SAFETY INSTRUCTIONS • The safety instructions of the product should always be considered and obeyed. • Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head. •...
Page 6
Consumer Information Sheet for Playground Surfacing Materials The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground equipment-related injuries resulting from falls to the ground surface are treated annually in US hospital emergency rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have the potential to be fatal, particularly when the injury is to the head.
III. SWING SET ASSEMBLY INSTRUCTIONS P A R T S L I S T P A R T S L I S T LK3001-Leg x 4 Swing Seat x 1 Trapeze Bar x 1 LK3002-Top Bar x 1 LK3003-Top Bar x 1 Lk2904-01 Web Swing Rope set x 2 LS1004-Sidestay x 2...
Page 8
M6x35mm x 4 Nut M8 x 36 Nut M6 x 8 M6x40mm x 2 Washer M8 x 14 Nut M6 x 2 M8x55mm x 10 M6x85mm x 2 M6 x 4 Plastic Washer M8 x 4 M6x50mm x 4 M8x65mm x 4 Anchor x 4 U Bolts M8 x 6 M8x50mm x 6...
Page 9
S E T U P STEP 1: LK3002/LK3003-Top Bar Assembly LK3002 M8X55MM x 2 Nut M8 x 2 LK3003 STEP 2: Bracket M8X65MM x 2 Top Bar Bracket Assembly For Glider For Swing Seat For Trapeze Bar Nut M8 x 2 For Web Swing set M8X65MM x 2 Bracket...
Page 10
STEP 3: LK3001-Leg Assembly M8 x 4 M8 x 55mm Upper Leg Upper Leg LK3001 LK3001 M8 x 55mm M8 x 4 Upper Leg Upper Leg LK3001 LK3001 Do not fully tighten bolts until frame is fully assembled. SWING SET ASSEMBLY INSTRUCTIONS...
Page 11
STEP 4: LS1004-Side Stay Assembly M8 x 2 Sidestay M8x50mm Lower Leg Lower Leg M8x50mm M8 x 2 Sidestay Lower Leg Lower Leg Check all bolts are securely fastened to ensure frame stability. SWING SET ASSEMBLY INSTRUCTIONS...
Page 12
STEP 5: Web Swing set Assembly on Top Bar LK3003 Refer to the position showing on top bar assembly step M8 x 4 DO NOT REMOVE THE KNOT FROM THE ROPE Minimum distance 40cm Nut M8 x 4 SWING SET ASSEMBLY INSTRUCTIONS...
Page 13
STEP 6: LK3004/3005-Glider set Assembly on Top Bar LK3002 Refer to the position showing on top bar assembly step V Bolt Set with Nut and washer M8 Nut M8 M8x50MM x 2pcs Check all bolts are securely fastened to ensure frame stability. M6x35MM x 4PCS M6x85MM x 2PCS Nut M6 x 2...
Page 14
STEP 7: Swing set Assembly on Top Bar LK3002 Refer to the position showing on top bar assembly step. M8 x 4PCS Swing set rope can be adjusted to suit user height. Check all bolts are securely fastened to ensure frame stability. Minimum distance 40cm SWING SET ASSEMBLY INSTRUCTIONS...
Page 15
STEP 8: Trapeze Bar Assembly on Top Bar LK3002 Refer to the position showing on top bar assembly step Check all bolts are securely fastened to ensure frame stability. Minimum distance 40cm...
Page 16
STEP 9: Anchor Assembly and Play zone The swing set is provided with anchor kits that must be used to secure swing. If you wish to add additional stability you may concrete the anchors as shown in below diagram. SWING SET ASSEMBLY INSTRUCTIONS...
WARNING - This product is to be used domestically in an outdoor family environment. - This equipment may not be used for collective and /or public purposes (playgrounds, camp grounds, schools, nursery schools, etc.) ANCHORING - Anchoring is recommended for additional stability - Anchor kits are provided, cement is not supplied.
VI. MAINTENANCE WARNING: Please keep for future reference. We recommend regular maintenance to be conducted at the beginning of each season as well as at regular intervals during the usage session for your play equipment to ensure all main parts/fixings are tightly secured, well-oiled and intact to avoid failure, injury or hazards.
If you have purchased this product from the Official Lifespan Kids website, please visit www.lifespankids.com.au/warranty-form For support outside of warranty, if you wish to purchase replacement parts or request a repair or service, please visit www.lifespankids.com.au/warranty-form and fill in our Repair/Service Request Form or...
Page 20
www.l i f e s p an k i d s . co m . a u...
Need help?
Do you have a question about the Lynx Metal Swing Set and is the answer not in the manual?
Questions and answers