Related Manuals for TOLSEN TOOLS FORCE XPRESS 79764
Summary of Contents for TOLSEN TOOLS FORCE XPRESS 79764
- Page 1 79764 SHEET SANDER INSTRUCTION MANUAL 120V~60Hz 2A (240w) SAVE THIS MANUAL ! You will need this manual for safety instructions, operating procedures and warranty. Put it and the original sales receipt in a safe dry place for future reference.
-
Page 2: Important Safety Information
SAFETY IMPORTANT SAFETY INFORMATION General Power Tool Safety Warnings WARNING: Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term ”power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. - Page 3 SAFETY 11. Stay alert, watch what you are doing and use ANSI-approved and breathing protection must common sense when operating a power tool. be NIOSH-approved for the specific hazards in Do not use a power tool while you are tired or the work area.
-
Page 4: Sander Safety Warnings
SAFETY tool for operations different from those qualified repair technicians at an authorized intended could result in a hazardous situation repair center. Improperly repaired tools could 26. SERVICE AND REPAIRS should be made by cause serious shock or injury. Sander Safety Warnings 1. -
Page 5: Specifications
SPECIFICATIONS SPECIFICATIONS Electrical Rating 120VAC / 60Hz / 2.0A No Load Speed 13,000 OPM Sandpaper Pad 4"W x 4-1/2" L LpA (Sound pressure level) LpA: 86dB(A) K=3dB(A) LwA (Sound power level) LwA: 96dB(A) K=3dB(A) Vibration level 17.9m/s K=1.5 m/s Note: Symbology Double Insulated WARNING mark concerning Risk of Eye Injury. -
Page 6: Before Use
SETUP SETUP Before Use Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product. WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that the power Switch is in the off-position and unplug the tool from its electrical outlet before adjusting the tool or installing accessories. - Page 7 SETUP & GENERAL OPERATING INSTRUCTIONS Assembly of a dust collector 1, Use a dust extraction device suitable for the material. carcinogenic or dry, use specific vacuums. 2, Insert the connection adapter into the outlet of the 4, A er completing the work, empty the dust sander.
-
Page 8: Maintenance And Servicing
MAINTENANCE AND SERVICING MAINTENANCE AND SERVICING WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn off the switch and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures. TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. -
Page 9: Troubleshooting
MAINTENANCE AND SERVICING Troubleshooting Problem Possible Causes Likely Solutions Tool will not 1. Cord not connected. 1. Check that cord is plugged in. start. 2. No power at outlet. 2. Check power at outlet. If outlet is 3. Tool’s thermal reset breaker unpowered, turn off tool and check circuit tripped (if equipped). - Page 10 SUZHOU TOLSEN TOOLS CO.,LTD. www.tolsentools.com TOLSEN is a trademark or registered trademark of TOLSEN TOOLS. All rights reserved. MADE IN CHINA...
Need help?
Do you have a question about the FORCE XPRESS 79764 and is the answer not in the manual?
Questions and answers