GHP Group TT15CPDG-1 User's Manual And Operating Instructions

Propane tank top construction heater

Advertisement

Quick Links

This Owner's Manual is provided and hosted by Appliance Factory Parts.
DYNA-GLO TT15CPDG-1
Owner's Manual
Shop genuine replacement parts for DYNA-GLO
TT15CPDG-1
Find Your DYNA-GLO HVAC Parts - Select From 146 Models
-------- Manual continues below --------

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TT15CPDG-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for GHP Group TT15CPDG-1

  • Page 1 This Owner's Manual is provided and hosted by Appliance Factory Parts. DYNA-GLO TT15CPDG-1 Owner's Manual Shop genuine replacement parts for DYNA-GLO TT15CPDG-1 Find Your DYNA-GLO HVAC Parts - Select From 146 Models -------- Manual continues below --------...
  • Page 2 TT15CL, TT30CL, TT15CDGP, TT30CDGP, TT15CPDG, TT30CPDG ANS Z83.7-2011 CSA 2.14-2011 Adequate ventilation must be provided. GHP Group, Inc. 6440 W Howard St Niles, IL 60714-3302 GENERAL HAZARD WARNING FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS, OR DAMAGE FROM THE HAZARDS OF FIRE, EXPLOSION, BURN.
  • Page 4: Table Of Contents

    TABLE OF CONTENTS General Safety Information ................3 - 4 Specifications ......................Product Features ..................... Heater Assembly ....................... Wiring Diagram ......................Propane Safety ......................Refilling The Propane Gas Tank ................Connecting Heater to Gas Supply ................8 - 9 Checking For Leaks ....................10 Lighting &...
  • Page 5: General Safety Information

    PROPANE TANK TOP HEATER PROPANE TANK TOP CONSTRUCTION HEATERS The heater is designed and approved for use as a construction heater under ANSI Z83.7, CSA 2.14. CHECK WITH YOUR LOCAL It is hard to anticipate every use which may be made of this heater. FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
  • Page 6: General Safety Instructions

    PROPANE TANK TOP HEATER GENERAL SAFETY INSTRUCTIONS Accidents are always tragic especially because so many of them could have been prevented with little care and judgment. There are some basic good practices, we hope you will follow for safe use of your heater. IMPORTANT SAFETY INFORMATION •...
  • Page 7: Heater Assembly

    PROPANE TANK TOP HEATER TT30 SERIES HEATER ASSEMBLY Tools Required: Estimated Assembly Time: Contents: Phillips head screwdriver 5 minutes Tank Top Heater (1) Tank Collar Bracket (1) M4x12 Machine Screws (2) DUAL BURNER MODEL The tank collar bracket must be assembled before the heaters can be attached to the propane tank. 1.
  • Page 8: Wiring Diagram

    PROPANE TANK TOP HEATER WIRING DIAGRAM ELECTRODE black earth yellow THERMOCOUPLE yellow M,P,U SAFETY VALVE NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
  • Page 9: Propane Supply

    PROPANE TANK TOP HEATER PROPANE SUPPLY This heater requires a 20 lb propane cylinder for operation. (Not included). The propane (LP) gas tank must also be equipped with the following: • A collar to protect the propane gas valve. • A shutoff valve terminating a Propane gas cylinder valve outlet as specified in the American National Standard for Compressed Gas Cylinder Valve Outlet and Inlet Connections.
  • Page 10: Connecting Heater To Propane Tank

    PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK Read and understand all safety information before connecting heater to propane tank. 1. (Applies to dual burner models only). Place heater onto tank with tank collar bracket over tank collar (Fig. 1) Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible directly opposite to the cylinder valve outlet.
  • Page 11 PROPANE TANK TOP HEATER PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK CONNECTING HEATER TO PROPANE TANK FIGURE 2 FIGURE 2 Spark Plug Electrode TT30 SERIES TT30 SERIES Tip Over Switch Tip over Switch Inlet Connector Inlet Connector Piezo (NOTE: some models only) Piezo (NOTE: some models only) Propane Tank Valve...
  • Page 12: Checking For Leaks

    PROPANE TANK TOP HEATER CHECKING FOR LEAKS Check all gas connections with a 50/50 soap and water solution to be sure they are tight and leak proof. The formation of bubbles indicate a gas leak. Correct all leaks before using the heater. •...
  • Page 13 PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS WHEN USING MATCH (CONTINUED) 1. Open Cylinder valve by turning FIGURE 4 counterclockwise Burner Front 2. Turn heater regulator knob clockwise to the Electrode “High” ( ) position. (Fig. 4) WARNING: Stand to the side of unit while Ignition Hole lighting.
  • Page 14: Turning Off The Heater

    PROPANE TANK TOP HEATER TURNING OFF THE HEATER 1. Tightly close propane tank valve by turning fully clockwise 2. Turn the heater regulator knob to the “OFF” ( ) position. Wait at least 30 minutes for the heater to cool before handling heater.
  • Page 15 PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS FOR PIEZO IGNITION MODELS (CONTINUED) 1. Stop! Read all safety information first. 2. Open cylinder valve by turning counterclockwise WARNING: Stand to the side of unit while lighting. Do not stand or have any part of your body over or in front of heater while lighting.
  • Page 16: Storage Of Heater

    PROPANE TANK TOP HEATER LIGHTING UNDER WIND CONDITIONS When using this heater outdoors on a windy day, it will be necessary to use a match or long stem butane lighter to ignite the burner. It may be difficult to keep the match lit long enough under windy conditions. Follow the “Lighting instructions when Using a Match”...
  • Page 17: Troubleshooting

    PROPANE TANK TOP HEATER TROUBLESHOOTING PROBLEM POSSIBLE
CAUSE CORRECTIVE
ACTION 1. Unit
will
not
light. 1. Valve
on
propane
cylinder
not
open. 1. Open
cylinder
valve
by
turning
counterclockwise. 2. Propane
cylinder
empty 2. Have
cylinder
refilled. 3. Regulator
not
in
"High"
position 3. Turn
regulator
to
"High"
position. 4. Excess
flow
device
triggered. 4. Close
cylider
valve,
wait
5
minutes
and
reopen
slowly. 5. Defective
Regulator. 5. Replace
Regulator
assembly. 2. Burner
will
not
stay
lit
when
 1. Tilt
switch
open 1. Correct
alignment
of
unit
to
ensure
it
is
vertical. gas
valve
plunger
released. 2. Wiring
of
thermocouple
 2. Check
wiring
connections
are
properly
engaged. 3.
  • Page 18: Exploded Parts Drawing

    PROPANE TANK TOP HEATER PROPANE TANK TOP HEATER REPLACEMENT PARTS ILLUSTRATION REPLACEMENT PARTS ILLUSTRATION TT15 SERIES TT15 SERIES TT30 SERIES TT30 SERIES NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
  • Page 19 THIS PAGE INTENTIONALLY LEFT BLANK.
  • Page 20: Warranty

    This limited warranty is extended to the original retail purchaser of this Forced Air/Convection/Radiant Heater and warrants against any defect in materials and workmanship for a period of one (1) year from the date of retail sale. GHP Group, Inc., at it’s option, will either provide replacement parts or replace or repair the unit, when properly returned to the retailer where purchased or one of our service centers as directed by GHP Group, Inc., within one (1) year of retail purchase.
  • Page 21: Warranty Registration

    6 0 0 5 3 - 3 2 0 7 Tel: ( 847 ) 324 - 5900 Fax: ( 847 ) 324 - 5901 SAVE THIS CARD! Toll Free (877) GHP Group ( 8 7 7 ) 4 4 7 - 4 7 6 8 www.ghpgroupinc.com Place...

This manual is also suitable for:

Tt15clTt30clTt15cdgpTt30cdgpTt15cpdgTt30cpdg

Table of Contents