Summary of Contents for SEELEY INTERNATIONAL Breezair EXQ210
Page 1
This Owner's Manual is provided and hosted by Appliance Factory Parts. Breezair EXQ210 Owner's Manual Shop genuine replacement parts for Breezair EXQ210 Find Your Breezair Evaporative Cooler Parts - Select From 59 Models -------- Manual continues below --------...
Page 2
OWNER’S MANUAL EXQ / EZQ / EXS Evaporative Coolers ILL1672-A (English) Original English Instructions...
IMPORTANT SAFETY INSTRUCTIONS FOR EUROPE READ AND SAVE THESE INSTRUCTIONS FOR This appliance can be used FUTURE REFERENCE. by children aged from 8 years and above and persons with WARNING - TO REDUCE THE reduced physical, sensory RISK OF FIRE, ELECTRIC or mental capabilities or SHOCK, OR INJURY TO lack of experience and...
IMPORTANT NOTES! Further, it is also a condition In areas where temperatures of warranty cover that each can cause water supply pipes item in the Maintenance to freeze, a drain down facility Schedule in the Owner’s should be provided during the Manual is performed with installation.
TABLE OF CONTENTS OPERATING YOUR COOLER MAGIQTOUCH CONTROLLER OPERATION MAGIQTOUCH CONTROLLER SETTINGS MENU ® About Appliance Min/Max Set Temperature Night Quiet Mode Manual Drain Pad Flush Drain and Dry AutoClean External Sensor MAGIQCOOL CONTROLLER SETTINGS Manual mode Auto mode MAGIQCOOL CONTROLLER OPERATION Turning the cooler on Preparing to start Manual mode...
Hello and congratulations on purchasing a Seeley evaporative MAGIQTOUCH CONTROLLER ® cooler SETTINGS MENU At Seeley International we manufacture Your MagIQtouch Controller contains a settings Breezair evaporative coolers from the highest menu which gives you access to information about ®...
MAGIQCOOL CONTROLLER MAGIQCOOL CONTROLLER SETTINGS OPERATION MagIQcool Wall Controllers can operate in manual or automatic mode. Manual mode Manual mode will allow you to change settings for operating the cooler, such as altering fan speeds, pump control and manual drain control.
MAGIQCOOL CONTROLLER MAGIQCOOL CONTROLLER OPERATION CONT OPERATION CONT Delayed Start or Stop You may then press the button to switch between COOL and VENT (where fresh The cooler can be programmed to start at a air is being delivered but not cooled). specific time or stop at a specific time.
MAGIQCOOL CONTROLLER OPERATION CONT. Programming In Auto Mode Service Mode (1)..Press the button. When a fault has been recognised by the wall control the word “Service” flashes on the (2)..Press the button until AUTO is screen. displayed. (3)..Press the button and the Service "Starts in"...
MAGIQCOOL CONTROLLER OPERATION CONT. If ‘02’ is displayed (1)..Check that the water supply tap to the cooler is turned on. (2)..Check that your local water authority haven’t temporarily disconnected the water in your area. If ‘04’ is displayed (1)..If your cooler is fitted with a drain valve, check that the drain is not blocked.
WATER MANAGEMENT Your evaporative cooler will be fitted with either open the drain valve and release saline water. a WaterMiser system, or a continuous bleed Fresh water will then be added diluting any ® system. Check with your dealer to determine minerals or salts accumulated.
If your or checks be carried out by an authorised cooler is fitted with a drain valve, no Seasonal Seeley International dealer or service agent. Maintenance is required. Climbing onto the roof can be hazardous...
REMOVING PAD FRAMES PAD FRAME POSITIONS To remove a pad frame: When re-fitting pads, ensure that they are fitted in their original positions. EXQ210, 1. Remove the clips holding the pad frame EZQ215 and all EXS model coolers have pads in place.
MAINTENANCE SCHEDULE Service Item Check/Adjust Clean Replace Water Distribution System Chillcel Pads (replace as required) Pad Retaining Washers/Pins Tank/Water Reservoir Pump Filter Water Probes System Washers, Seals and O’Rings (replace as required) Drain Valve/Bleed Funnel operation Component Function Pump operation Drain Valve operation Motor Operation Solenoid operation...
If your controller prompts you to call a service agent, please contact your local Seeley International authorised dealer or the service number on the back of this manual. Important! In an emergency we recommend that you immediately cease operating the appliance,...
HOW TO REGISTER YOUR PRODUCT WARRANTY (AUSTRALIA ONLY) Warranty Information section HOW TO REGISTER YOUR PRODUCT WARRANTY (Australia only) Please register your warranty online by visiting www.seeleyinternational.com and following these steps: Step 1 Select “GET SUPPORT” and “REGISTER A WARRANTY” Step 2 Select the brand of the product you purchased Step 3...
Warranty Details (Australia only) In this warranty: We or us means Seeley International Pty Ltd (Seeley) ABN 23 054 687 035, and our contact details are set out at the end of this warranty; You means you, the original end-user purchaser of the Goods;...
Page 18
Plug Connect models only parts are covered, not labour) but you will be responsible for: the cost of travel incurred for a Seeley International service agent to get to and from the location of the Goods if the location of the Goods is either: (i) outside the metropolitan areas of the capital cities; or (ii) more than 35 kilometres from an authorised Seeley International branch or service representative;...
Page 19
PRIVACY NOTICE Seeley International Pty Ltd ABN 23 054 687 035 will use the personal information you provide us with to provide warranty support for the product you have purchased and to inform you about other products and services. If you choose not to supply us with the information requested, we may be unable to provide you with warranty support.
Page 21
6 WITTON ROAD, FOUNDERSVIEW SOUTH, MODDERFONTEIN 1609, GAUTENG, SOUTH AFRICA It is the policy of Seeley International to introduce continual product improvement. Accordingly, specifications are subject to change without notice. Please consult with your dealer to confirm the specifications of the model selected.
Need help?
Do you have a question about the Breezair EXQ210 and is the answer not in the manual?
Questions and answers