Before Using; Features - FUTABA CDR5000 Instruction Manual

Features

• The linear current charger with advanced peak detector and automatic cutoff circuit with MOSFET
can charge battery up to 100% without overcharging.
• The CDR-5000 can charge, discharge and cyclically charge/discharge batteries such as NiCd and
NiMH for motors, transmitters and receivers.
• DX port (specially for batteries for motors): 1-36 cells, 50-9999mAh
• TX/RX port (specially for batteries for transmitters and receivers): 1-8 cells, 50-2500mAh
• Large reconfigurable LCD display (192 x 128 dots) + Backlight
DX and TX/RX:
Output current, output voltage, set charge current, set discharge current, peak voltage, battery
capacity, unit status (charge/discharge/cycle/no battery is connected/ready/short/reverse connection/
delay) and etc.
DX only:
Average discharge voltage, internal relative resistance, time, power level, matched level, outside
temperature, humidity, battery temperature, input voltage and so on.
• DX port: The maximum voltage to stop charging can be set at: 0.1-62V
• DX port: The function of "Zero delta volt (0DV)" is available.
Setting range: 3mV - 50mV/cell for charging a NiCd battery
• DX port: Independent terminal (Terminal Harness) will provide accurate voltage, showing the levels
between the serially composed cells by bar graph and numerical percentage on the screen.
• DX port: Temperature sensor to protect batteries. DELAY MODE functions when the temperature
exceeds 40ºC during a cycle charging/discharging.
• Thermo Stand with built-in temperature sensor (option)
• Discharge cut-off timer.
• DX and TX/RX can be operated at the same time.
• 2 blue LEDs and 2 red LEDs indicate the status of charging and discharging.
• Reverse polarity protected.
• Five built-in cooling fans
• Protector to prevent users from touching heat sink

Before Using

7