Charging/Discharging; Setting Parameters For Charging/Discharging - FUTABA CDR5000 Instruction Manual

Charging/Discharging

1. Setting Parameters for Charging/Discharging

Caution: Before connecting a battery to charge/discharge it to CDR-5000, be sure to
check all parameters on the SET-UP screen and correct them if necessary. It is pos-
sible to change each parameter while charging/discharging is being conducted, how-
ever the data will become unreliable.
[Confirmation and setting of parameters in the SET-UP screen]
DX SET-UP: This screen is for DX port. (Rapid charge/discharge batteries for motors)
TX&RX SE-UP: This screen is for TX/RX port. (Batteries for transmitters and receivers)
<Operation key>
Push "Set-up" key to switch DX SET-UP and TX&RX SET-UP. The selected memory-number will
blink.
Push "Enter" key to select the parameter in the SET-UP screen.
Move cursor by pushing " " or " " keys (to select the digit.)
Set number by pushing " " or " " keys.
[How to call SET-UP screen]
While keeping the battery disconnected to the DX port,
push any of the following keys, "Data", "Graph", "Enter",
" " and " " in the opening screen to go to DX DATA screen.
Then push "Set-up" key in the DX DATA screen to SET-
UP screen.
15