Operation Precautions - FUTABA 3PM Instruction Manual

Operation Precautions

Warning
Do not operate two or more models
on the same frequency at the same
time.
Operating two or more models at same time on the
same frequency will cause interference and loss of
control of both models.
AM, FM (PPM) PCM and HRS are different
methods of modulation. Nonetheless the same fre-
quency can not be used at the same point in time,
regardless of the signal format.
Do not operate outdoors on rainy
days , run through puddles of water or
when visibility is limited.
Should any type of moisture (water or snow) enter any
component of the system, erratic opreation and loss
of control may occur.
Extend the transmitter antenna to its
full length.
If the transmitter antenna is not fully extended the op-
erating range of the radio will be reduced.
Check the transmitter antenna to be
sure it is not loose.
If the transmitter antenna works loose, or is discon-
nected while the model is running signal transmission
will be lost. This will cause you to lose control of the
model.
Prohibited Procedures
Interference could cause loss of control. Improper in-
stallation of your Radio Control System in your model
could result in serious injury.
Your judgment is impaired and could result in a dan-
gerous situation that may cause serious injury to your-
self as well as others.
Mandatory Procedures
Problems with the radio control system as well as im-
proper installation in a model could cause loss of con-
trol.
Do not operate in the following
places.
-Near other sites where other radio control
activity may occur.
-Near people or roads.
-On any pond when boats are present.
-Near high tension power lines or communi-
cation broadcasting antennas.
Do not operate this R/C system when
you are tired, not feeling well or under
the influence of alcohol or drugs.
Always perform an operating range
check prior to use.
(Simple range test method)
Have a friend hold the model, or clamp it down or
place it where the wheels or prop can not come in
contact with any object. Walk away and check to
see if the servos follow the movement of the con-
trols on the transmitter. Should you notice any ab-
normal operation, Do not operate the model. Also
check to be sure the model memory matches the
model in use.
7